LAUSR

Complex bony defects such as those of the orbital floor are challenging to repair. Additive manufacturing techniques open up possibilities for the fabrication of implants with a designed macro-porosity for the reconstruction of such defects. Apart from a designed macro-porosity for tissue ingrowth, a micro-porosity in the implant struts will be beneficial for nutrient diffusion, protein adsorption and drug loading and release. In this work, we report on a low-temperature extrusion-based additive manufacturing method for the preparation of composite photo-crosslinked structures of poly(trimethylene carbonate) with bone-forming nano-hydroxyapatite and noricaritin (derived from bone growth stimulating icariin). In this method, we extrude a dispersion of nano-hydroxyapatite and noricaritin particles in a solution of photo-crosslinkable poly(trimethylene carbonate) in ethylene carbonate into defined three-dimensional structures. The ethylene carbonate is subsequently crystallized and extracted after photo-crosslinking. We show that this results in designed macro-porous structures with micro-pores in the struts. The dispersion used to fabricate these structures shows favorable properties for extrusion-based processing, such as a sharp crystallization response and shear thinning. The formed photo-crosslinked materials have a micro-porosity of up to 48%, and the E modulus, ultimate tensile strength and toughness are in excess of 24 MPa, 2.0 N/mm2 and 113 N/mm2 respectively. A sustained release of noricaritin from these materials was also achieved. The results show that the technique described here is promising for the fabrication of micro-porous photo-crosslinked composite structures of poly(trimethylene carbonate) with nano-hydroxyapatite and that these may be applied in the reconstruction of orbital floor defects