LAUSR

The concept of soil water contents at field capacity (FC at 0.33 MPa) and at wilting point (WP at 15 MPa) is often used to explain plant water availability and as maximal and minimal limits on observed soil water content. Field observations often differ, however, from laboratory-determined FC and WP water content values. Moreover, as more capable sensors have become available and graphical plots of soil water dynamics have become common, plotting of FC and WP lines on such graphs often reinforces these differences and engenders confusion rather than enlightenment. Resolving this confusion has been greatly eased by the introduction of soil water sensors that encapsulate an entire time domain reflectometry (TDR) system in individual sensor heads and the recent availability of a reader for capturing georeferenced values of the TDR waveform and estimated values of soil volumetric water content (VWC), permittivity, temperature, and bulk electrical conductivity. The present study illustrates the typical confusion with season-long graphs of soil water content that greatly exceed the FC values for individual soil horizons, and it resolves the confusion with concurrent and co-located TDR sensor readings and volumetric soil sampling to ascertain sensor accuracy. It was found that sensor readings were reasonably accurate (RMSE = 0.01 m3 m−3) across a range of textures from fine sandy loam to clay, even though some measurements were up to 0.19 m3 m−3 larger than FC values. Water contents in a sandy eluviated horizon above a dense clay were larger than FC due to the clay layer impeding water flow and perching water in the sand, augmented by the capillary fringe in the fine sand. Confusion was in part created by plotting water content for four different depths of different textures but plotting the FC and WP values for only one soil texture. Misperception of water available for crops was greatly reduced by converting the water content values to equivalent water depth values for the four soil layers and plotting only the soil water storage depth for the entire profile depth covered by the sensing network. The ambiguity was further reduced by determining the maximum value of soil water storage for the season and calculating soil water depletion by subtracting the maximum value from the soil water storage throughout the season. When this was done, it was easy to see depths of water removed from the soil and needing replacement, and to see the extra soil water depletion that occurred when a plot was not irrigated.