LAUSR

In this article, Ni-Co/GO nanocomposite was fabricated by AC pulse electrodeposition method. The room temperature strength tests and the superplasticity of the nanocomposite were investigated by the tensile tests. A 5 × 5 micro-arrayed deep-drawing die was designed to explore the feasibility of micro-forming. The as-deposited material has a narrow grain size distribution with a mean grain size of 50 nm. The addition of GO as a reinforcing phase can effectively enhance the room temperature tensile strength of the nanocomposite, but reduce the plasticity. When adding GO to the plating bath, a maximum elongation of 467% was observed for the specimen with a GO content of 0.01 g/L at 773 K and a strain rate of 1.67 × 10−3 s−1 by tensile tests. Micro-arrayed deep-drawing tests were subsequently performed with male die diameter of 0.58 mm and female die diameter of 0.8 mm. The experimental relative drawing height values were measured and compared with the deep-drawing parts without GO additive. It is found that the micro-arrayed deep-drawing with rigid male die at high temperature was feasible and forming parts with good shape could be got. The thickness distribution analysis of the deep-drawing parts showed that wall thickness changed ranging from 53 to 95 μm, and the thickness reduction at the punch fillet is the most obvious.