LAUSR

In this study, the evolution of pores structure in cold-sprayed Ti6Al4V coating (TC4) was analyzed before and after 600-1100 °C heat treatment. It was found that almost no change happened to pores under the heat treatment temperature below 600 °C. When the heat treatment temperature was increased to 700 °C, the coating recrystallized, and pores turned to spheroid and healed because of the “bridging” effect. Some of the pores coarsened after 800 °C and 900 °C heat treatment. This kind of phenomenon grew severer when the heat treatment temperature increased to 1000 °C and 1100 °C. On the whole, with the increment of temperature, for the coating prepared at relatively low temperature, apparent porosity measured by image analysis method tended to go down first and then up, but it decreased all the time for the coating prepared at relatively high temperature. The reason for this phenomenon was contributed to the bonding state of particles in the coating. Only when there were fewer weakly bonded interfaces, the detachment between the particle interfaces which may be caused by release of residual stress did not occur, and there was no pores expansion and internal connectivity, so the porosity continuously decreased.