LAUSR

A common failure in a certain type of gas turbine, observed during the first periodic inspection, is radial cracks in the tip plate of gas fuel nozzles. Here, each gas turbine has 18 nozzles. In all nozzles and in all similar units, these cracks of lengths ranging from 1 mm to a maximum of 14.5 mm are observed. As prescribed by the manufacturer, the defective part must be removed and replaced by welding and machining of a new one. But this problem is repeated and observed in the next periodic visits, and in all units. Depending on the number of nozzles in each gas turbine unit and the number of units in total, these repairs are very expensive and time-consuming. In this paper, the failure is analyzed and the causes of the cracks in the nozzles are investigated. Studies show that the main causes of nozzle failure are residual stresses caused by welding and thermal stresses caused by the start-up and shutdown processes. According to results, a solution has been proposed to release these residual and thermal stresses. After the implementation of this method in 1998, no more failure has been reported by the repair team, which proves the effectiveness of this solution. Since this paper has been prepared based on technical reports from the years between 1996 and 1998, the cited references of this paper are these technical reports.