The incorporation of inorganic nanoparticles into thin film composite forward osmosis (TFC FO) membranes is an effective method to alleviate internal concentration polarization (ICP) and enhance the flux performance of… Click to show full abstract
The incorporation of inorganic nanoparticles into thin film composite forward osmosis (TFC FO) membranes is an effective method to alleviate internal concentration polarization (ICP) and enhance the flux performance of the FO membrane. In this paper, synthetic hydrophilic rod-like porous nano-hydroxyapatites (PNHAs) were doped into polysulfone (PSf) casting solution to form support layer by phase inversion; further interfacial polymerization was carried out to prepare a high performance TFC FO membrane. The results showed that the incorporation of PNHAs not only improved the thickness, porosity, hydrophilicity, and connectivity of the support layer, but also enhanced the roughness of the active layer. The measured mass transfer parameters prove that these improvements were beneficial. Further FO experiments showed that when using deionized water as the feed solution and 1mol/L NaCl as the draw solution, TFN 0.75 showed higher water flux than TFC FO membrane in both AL-FS (18.5 vs 7.16 L/m2·h) and AL-DS (33.26 vs 9.93 L/m2·h) modes. Reverse salt flux had not increased significantly. At the same time, TFN 0.75 (697 μm vs 1,960 μm) showed the smallest structural parameter. This study shows that PNHA is a suitable nanomaterial for mitigating the ICP effect of FO membranes.
               
Click one of the above tabs to view related content.