LAUSR

This paper develops a model for studying the effect of joint clearances on the end-effector’s loci for planar parallel manipulators with 2 degree-of-freedom (DOF). The condition for developing end-effector loci equations with respect to the joint clearance relies on the fact that at least one point of contact is always presented in each joints. The motivation of this work lies in the fact that the proposed procedure allows the study of parallel manipulators that can be considered as design concepts for developing an x-y cutting table for a textile industry. Numerical simulations enable to compare three 2-DOF planar parallel manipulators architectures: i) 2-RRR, ii) 2-RPR, and iii) 2-RPR. A Monte Carlo simulation allows us to find the area of possible end-effector locations for a specific value of clearance. Also, the equations allow us to find the largest distance from the desired location to the one obtained considering clearance. Findings shed some lights on establishing which parallel manipulator is less affected to joint clearance.