LAUSR

Most of the surface reserves of copper minerals are oxidized while underground mining leads to rich silica–chalcopyrite–pyrite ore. Based on the challenges of the twenty-first century, the (bio)-hydrometallurgy processing is suggested as an alternative route to replace conventional techniques. However, the search for a sustainable metallurgy and/or more effective method to decrease impurities for efficient solvent extraction led to a comparative study of the removal performances of silica and solid colloidal particles from bioleachate solution by comparing the techniques using Shellsol set #2325 and Magnafloc set #1597, respectively. Three ratios (thinner/aqueous) or/and (coagulant /aqueous) of 1/2, 1, and 3/2 were assessed, along with the disengagement time and the required absorbed dose of Magnafloc 1597. The search for the alternative route also sought to ensure that the requirements in terms of concentration values at solvent extraction stage did not exceed 500 and 75 ppm, respectively. Findings show that the diluent/wash method is less efficient in terms of the removal performances of silica and solid colloidal particles from the bioleachate solution, but the phase disengagement time was similar, being comparatively around 150 s. The results of Magnafloc 1597 coagulation tests show removal performances of silica and colloidal particles from the bioleachate solution to be greater than 300 ppm, with a volume ratio of 1/1 for recovery rates of 68 and 58%, respectively, for SiO2 and colloidal solids in suspension. In comparison, the employment of Shellsol 2325 achieved silica removal efficiencies of 20.92 and 40%, respectively, of SiO2 and colloidal fine particles in suspension. A decreased phase separation time in aqueous continuity from 245 to 148 s has been recorded with a ratio of 1/1 (thinner or coagulant/aqueous). On the other hand, coagulant concentration of 300 ppm was retained. Hence, it could be assumed that the coagulation showed better results than the washing method.