LAUSR

Abstract The depth of penetration (DOP) method is a well-known ballistic test method for characterisation and ranking of ceramic armour materials. The ceramic tile is bonded to a backing material of semi-infinite thickness, and the penetration depth of the projectile gives a measure of the performance of the ceramic. There is, however, an inherent variability in the results from this test method. In this work, the accuracy and the variability of the DOP method has been investigated in a round robin exercise. Six ballistic test centres took part in the exercise. A test protocol was developed, in which the threat type (projectile and impact conditions) and a procedure on how to prepare the targets were specified. The targets consisted of alumina tiles of two different thicknesses that were bonded to polycarbonate backing cubes. Two different 7.62 mm armour piercing projectiles were employed; one with a hard steel core and one with a tungsten carbide core. The projectiles and the other materials all came from single material batches in order to avoid batch-to-batch variations in material properties. These materials were distributed between the ballistic test centres. The test results of the different ballistic test facilities were collected and compared. There was not a lot of variation between the average DOP values obtained at each laboratory, but the variation in penetration depth between shots was high. The consequence of this variation may be less confidence in the test results, and a statistical method was used to evaluate the required number of tests that are sufficient to obtain an average result with high confidence. In most cases, the required number of tests is much higher than what is practically feasible. This work was conducted as part of the European Defence Agency-project CERAMBALL.