LAUSR

Graphical abstract Figure. No Caption available. HighlightsDecrease in IDR with an increase in chain length of the counterion observed using UV‐imaging.Developed interfacial area ratio (Sdr) showed significant surface gains for the compacts for IDR determination.Particulates on surface compacts and observed cracks responsible for inflated IDR values.Imaging of surface should be taken into consideration prior IDR determination. ABSTRACT The optimisation of the pharmaceutical properties of carboxylic acid drugs is often conducted by salt formation. Often, the salt with the best solubility is not chosen due to other factors such as stability, solubility, dissolution and bioavailability that are taken into consideration during the preformulation stage. This work uses advanced imaging techniques to give insights into the preformulation properties that can aid in the empirical approach often used in industry for the selection of salts. Gemfibrozil (GEM) was used as a model poorly soluble drug. Four salts of GEM were made using cyclopropylamine (CPROP), cyclobutylamine (CBUT), cyclopentylamine (CPENT) and cyclohexylamine (CHEX) as counterions. DSC, XRD and SEM were used to confirm and characterise salt formation. IDR obtained using UV‐imaging up to 10 min for all the salts showed that an increase in the chain length of the counterion caused a decrease in the IDR. Past the 10 min mark, there was an increase in the IDR value for the CPROP salt, which was visualised using UV‐imaging. The developed interfacial (surface) area ratio (Sdr) showed significant surface gains for the compacts. Full dosage form (capsule) imaging showed an improvement over the GEM for all the salts with an increase in chain length of the counterion bringing about a decrease in dissolution which correlated with the obtained UV‐imaging IDR data.