LAUSR

Abstract The research work dealt with measurement and analysis of the effects of cutting conditions include Spindle speed (n), Feed rate (f) and Depth of Cut (ap) on Arithmetic Average Surface Roughness (Ra) and Material Removal Rate (MRR) in micro turning operation. C360 Copper alloy and Tungsten Carbide insert are chosen as the work and tool material respectively. Taguchi L27 Orthogonal Array based Experiments were incorporated and micro pin of size 800 µm are fabricated in micromachining tool. Quality of the measured results validated with Type-‘A’ uncertainty analysis and observed a standard deviation of ±0.007 µm. It is observed that, combination of lower range of process variables (within the given range) yields fine surface finish and higher range of variables yields maximum MRR but poor surface finish. Analysis of variance was performed and inferred that, “ap” has significant influence on Ra and MRR. Also observed that, higher ‘f’ affects surface finish by marking phenomenon. Parameters optimization was carried out using Genetic Algorithm (GA). Optimum values of Ra and MRR were found as 0.031 µm and 0.0768 mm3/s respectively and their process parameters are n = 1686 rev/min, f = 10.6242 µm/rev and ap = 99.45 µm. Finally accuracy of GA results validated with confirmation experiments.