LAUSR

Abstract The demand for higher power densities in gear applications leads to the use of high-strength materials. This poses a challenge for manufacturing technologies with regard to the machinability of these materials. Even though gear hobbing is one of the most common technologies for gear machining, only limited investigations on the machinability of high-strength materials have been carried out. In this paper, the machinability of different workpiece materials by gear hobbing under dry cutting conditions is investigated. The tool life and wear behavior of powder metallurgical high-speed steel PM-HSS S390 and sintered tungsten carbide – cobalt WC-Co K30 tools with an AlCrN coating were analyzed. 20MnCr5 case-hardening steel, 42CrMo4 tempered steel and EN-GJS-700-2 cast iron were machined using the fly-cutting trial as an analogy process for gear hobbing. To identify a respective target tool life of LT,10 = 10 m, the cutting speed was varied while the feed rate was defined based on the respective tool concept and cutting substrate. The experiments showed a good machinability of the soft state material 20MnCr5 with PM-HSS S390 tools up to a cutting speed of vc = 350 m/min. A machining of the high-strength materials 42CrMo4 and EN-GJS-700-2 resulted in high tool wear or catastrophic tool failure. Even at low cutting speeds of vc = 50 m/min, the target tool life LT,10 could not be reached. When using WC-Co K30 tools, tool lives of LT > 6 m and cutting speeds up to vc = 400 m/min were feasible when machining 42CrMo4 tempered steel. For the machining of EN-GJS-700-2 cast iron, high abrasive tool wear was observed, which led to short tool lives of LT 15 m could be achieved.