LAUSR

Immersion precipitation three-dimensional printing (ip3DP) and freeform polymer precipitation (FPP) are unique and versatile methods of 3D printing to fabricate 3D structures based on nonsolvent-induced phase separation via direct ink writing (DIW). Immersion precipitation involves complex dynamics among solvents, nonsolvents, and dissolved polymers, and the printability of 3D models in these methods requires further understanding. To this end, we characterized these two methods of 3D printing using polylactide (PLA) dissolved in dichloromethane (7.5-30% w/w) as model inks. We analyzed the rheological properties of the solutions and the effect of printing parameters on solvent-nonsolvent diffusion to achieve printability. The PLA inks exhibited shear-thinning properties, and their viscosities varied over three orders of magnitude (10-1∼102 Pa·s). A processing map was presented to understand the ideal ranges of the concentration of PLA in inks and the nozzle diameter to ensure printability, and the fabrication of complex 3D structures was fabricated with adequate applied pressure and nozzle speed. The processing map also highlighted the advantages of embedded 3D printing over solvent-cast 3D printing based on solvent evaporation. Lastly, we demonstrated that the porosity of the interface and inner structure of the printed objects was readily tailored by the concentration of the PLA and the porogen added to the ink. The methods presented here offer new perspectives to fabricate micro-to-centimeter objects of thermoplastics with nanometer-scale inner pores and provide guidelines for successful embedded 3D printing based on immersion precipitation.