LAUSR

This paper considers the instabilities of imploding aluminum metal-puff Z-pinches with an outer plasma shell. An experiment was performed on the GIT-12 generator (3.2–3.6 MA, ∼1 μs implosion times, and ∼15 cm initial Z-pinch radius). It was shown that the density profile of the Z-pinch material had the dominant effect on the growth and suppression of instabilities. Two Z-pinch load configurations were used. The first configuration provided a tailored density profile (TDP) [A. L. Velikovich et al., Phys. Rev. Lett. 77, 853 (1996)], which ensured the suppression of the magneto-Rayleigh–Taylor (MRT) instability in the Z-pinch. For the second configuration, the density profile was changed in such a way that a density notch from 10 to 0.5  μg/cm3 occurred at a radius of about 3 cm from the Z-pinch axis. The notch in the density profile and the nonmonotonic increase in density resulted in a completely unstable compression of the Z-pinch. This gave rise to large-scale instabilities, which were detected by optical diagnostics. The instabilities grew and were not suppressed even in the stagnation phase, despite a sharp increase in the density of the Z-pinch material near the axis. The results were interpreted using the model proposed by Curzon et al. [Proc. R. Soc. London A 257, 386 (1960)]. The total instability amplitude is the sum of the amplitudes of MRT and magneto-hydrodynamic (MHD) instabilities. The growth of the total instability in the density notch region is due to the development of MRT instability. Thus, if the density profile has a notch, the Z-pinch compression in the stagnation phase occurs under strong perturbations at the magnetic field/plasma interface. This results in a dramatic growth of MHD instabilities. Hence, a stable implosion of a Z-pinch with TDP is possible only if the density increases monotonically toward the axis.