LAUSR

ABSTRACT This article presents investigations on and analysis of surface finish of meso bevel and helical gears made of stainless steel (SS 304) manufactured by wire electric discharge machining (WEDM) process using thin soft plain brass wire of 0.25 mm diameter. Effects of eight WEDM process parameters, namely, peak current, pulse-on time, pulse-off time, wire feed rate, wire tension, servo-gap voltage, dielectric pressure, and cutting speed on average and maximum surface roughness of the meso bevel and helical gears have been studied by conducting 31 experiments using one-factor-at-a-time approach to identify their optimum ranges/values for further experiments. Tooth profile, microstructure, microhardness, and topography of tooth flank surface have been studied for the best quality meso gears. Average and maximum surface roughness of tooth flank surfaces of meso bevel and helical gears increase with increase in peak current, servo-gap voltage, pulse-on time, wire feed rate, wire tension and cutting speed, and decrease with increase in pulse-off time while dielectric pressure does not significantly influence surface roughness. This work establishes that WEDM process can be an economic and sustainable manufacturing alternative for net-shaped meso-sized bevel and helical gears having better surface finish which will eliminate need of any subsequent finishing processes.