LAUSR

Due to the advancement in the field of biocomposites, the role of plant fiber-reinforced composites has increased over the last few years. Now, these materials are used for both serviceable and non-serviceable applications. The components to be manufactured by natural fiber-reinforced composites can be created using simple manufacturing techniques. However, joining of these manufactured parts has been the major difficulty faced by manufacturers. Extensive research has been carried out in drilling of polymer matrix composites and metal matrix composites, however, the studies on the behavior of natural fiber reinforced composites are limited. Hence an attempt has been made to study the mechanical characterization, machinability and microstructural study of Discontinuously Reinforced Sisal Fiber Polyester (DRSFP) composite laminates. From the experimental results it is observed that Moisture absorption was 1.4% for 40 hours' time period due to porosity content, the lumen and fiber-matrix adhesion, at higher load frictional thrust increases and resulted in increased debonding and fracture, main effects plot for three body abrasive wear indicates the selection of less Load (4kg) and less speed (100 rpm) results in the best combination to get minimum abrasive wear value, selection of Spindle speed (1500 rpm), Feed rate (10 mm/min) and Point angle (90°) resulted in the best combination to get better surface roughness and minimum delamination. From the SEM micrographs of the drilled hole of DRSFP composites, it is observed that the hole drilled at point angle 118° has severely damaged surface compared to point angle 90° and 104° due to more fiber pull-out, surface and subsurface cracks (radial direction), de-bonding of fiber-matrix.