LAUSR

In this study, the hot tensile test was carried out using the extruded and annealed Mg-1Al-6Y alloy. The effect of temperature and strain rate on the hot tensile deformation behavior of the alloy was systematically studied at different temperatures (200 °C ∼ 350 °C) and different strain rates (8 × 10−5 s−1 ∼ 1.6 × 10−3 s−1). In addition, the effect of temperature on the evolution of microstructure when the strain rate is 1.6 × 10−3 s−1 was investigated. The results showed that as the temperature increased or the strain rate decreased, the peak stress decreased and the elongation increased. Hot tensile at different temperatures all increased the texture intensity, and the microstructure after deformation showed obvious characteristics of basal fiber texture ([0001]⊥ED). Correspondingly, the weaker [−15–40]//ED texture before deformation transformed into a stronger [01–10]//ED fiber texture. After deformation, the average Schmid factor (SF) of each non-basal slip was significantly increased compared with the average SF before deformation, indicating that abundant non-basal slip was activated during the deformation. When the deformation temperature was 300 °C, dynamic recrystallization (DRX) occurred significantly, and the DRXed grains accounted for 15.9%. DRX was a combination of continuous dynamic recrystallization (CDRX) and discontinuous dynamic recrystallization (DDRX). Furthermore, the calculated activation energy of the alloy was about 98.8 kJ mol−1. Comprehensive research showed that the hot tensile deformation mechanism mainly included intragranular slip, grain boundary slip (GBS) and DRX.