LAUSR

This paper aims to introduce a novel concept of a double-wire feed (DWF) to alleviate heat accumulation and improve the cooling rate of the molten pool in gas tungsten arc (GTA)-based additive manufacturing (AM), in which the former wire is fed into the arc and the latter wire is melt by the molten pool.,The microstructure, phase composition and mechanical properties of 308 L stainless steel components built by single-wire feed (SWF) AM and DWF-AM are compared, and the differences are analyzed in detail.,The microstructures for both wire feeding modes include δ and γ phases. Compared with the SWF-AM, the sample fabricated in the DWF-AM exhibits finer microstructure, and the microstructure in the middle region is transformed from columnar grains to cellular grains. Microhardness of the sample produced in the DWF-AM is higher than the SWF-AM. In comparison to the SWF-AM, the tensile strength of the specimen fabricated using the DWF-AM reaches 571 MPa and increases by 16.14%.,This study proposes a novel concept of the DWF-AM to reduce heat accumulation as well as enhance the cooling rate of the molten pool, and improved mechanical properties of the 308 L stainless steel component are obtained.