LAUSR

Low force ripples from permanent magnet linear motors (PMLMs) are typically essential requirements in a wide range of demanding control applications with high motion quality. Apart from the sources present in rotary PM machines, phase unbalance due to the end effect is another major contributor of the thrust force ripples in the PMLMs. In this paper, the phase unbalance and induced force ripples are investigated in the case of a planar PMLM typically equipped with single-layer concentrated windings and quasi-Halbach magnets. It demonstrates that although the PMLM is quite carefully deigned to minimize the end effect, the phase unbalance still exists, including both the amplitude and phase position unbalances. And the phase unbalances give rise to even order force ripple harmonics, in which the 2nd-order force ripple is particularly significant. In order to compensate the end effect and the unbalance between the three phases, a novel PMLM topology is presented, in which the width of the two end teeth (instead of the edge teeth) is adjusted to reduce the force ripple. And the impact of the end teeth width on the ripple force magnitude is further revealed. It is shown that by proper design of the end teeth width, the 2nd-order force ripple of the PMLM can be minimized to quite a low extent. In comparison with the original design, the 2nd-order force ripple factor of the novel topology has been suppressed from 0.4% to less than 0.03% in the case study. Such a technique has provided a new way of force ripple minimization, and is applicable to other types of linear motors or actuators with appropriate changes.