LAUSR

The shear friction capacity calculated using clauses 11.6.4 to 11.6.10 in ACI 318-14 or clauses 11.5.1 to 11.5.6 in CSA-A23.3-14 do not take into consideration the effect of edge distance on the shear friction capacity. The main objectives of this research are to study the effect of edge distance on the shear friction capacity by means of a specifically designed experimental program, to determine the minimum edge distance to develop the shear friction capacity, and to derive an expression for reduction of shear friction capacity for edge distances less than the minimum edge distance. The study involved testing eight specimens. In four specimens, a steel plate was anchored using welded reinforcing steel bars, and in the other four specimens the steel plate was anchored using headed concrete anchors (bolts) (HCA). The steel plates were tested under shear load at edge distances of 75, 150, 225, and 300 mm (3.0, 6.0, 9.0, and 12.0 in), for the two types of anchorage. The results were compared to design values according to ACI 318-14 and CAN/CSA-A23.3-14 standards. An equation is derived to compute the minimum edge distance after which the full shear friction capacity is developed. Another equation is derived to compute the proposed shear capacity for reinforcing bar anchors for edge distances less than the minimum edge distance.