LAUSR

Dimensional accuracy of machining translates into susceptibility to defects in assembly of furniture elements. In the initial drilling phase, the tip of the drill may slip due to the properties of the workpiece, which may result in inaccurate machining. Taking this into account, it was decided to investigate this phenomenon for drilling in the side of the plywood board. Samples for testing were made of 18 mm thick, 13 layer birch-alder plywood, covered with melamine film, glued with phenol-formaldehyde glue. With the use of an industrial dowel drilling machine, 30 holes in each of three examined layer were made. All holes were made parallel to the layers – on the side of the plywood board, and their axes were located in three adjacent layers: the birch veneer layer, the adhesive layer, and the alder veneer layer. Two types of geometric accuracy of holes were analyzed: the distance between the real center of the hole and the nominal position and also the inclination of the hole axis from the nominal axis. The holes made in the adhesive layer showed approximately twice larger deviations compared with the holes made in two adjacent layers of veneer. There was no significant relationship between the deviations of the angle of holes axis and the inaccuracies in the position of their centers. Main conclusion: When drilling in the side surface of the plywood board, less accurate holes are obtained if the hole axis is located in the adhesive layer, and there is more accuracy if the hole axis is located in the veneer layer.