LAUSR

Both direct and indirect heating compression methods were proposed to satisfy the requirement of industrial steam compression and supply. The compression process in a single-screw compressor was analyzed with the determination of different inlet and outlet boundary conditions. Considering the misalignment of meshing pairs caused by the offset of the star wheel axis and screw origin, the differential expansion of the vertical meshing pair was further analyzed. The inner ring of the sealing end face, the wall of the inner ring of the bearing at the inlet and outlet ends, and the bottom surface of the bracket were analyzed by different coordinate systems and different constraints, thus facilitating the design and selection of the single screw. The critical point for the design of a steam-type single-screw compressor is an outlet temperature of 350 °C and an outlet volume flow rate of 130 m3/min. At a flow rate of 130 m3/min, when the temperature exceeds 350 °C, the reliability of the compressor is still limited, and the differential expansion of the meshing pair exceeds 0.3 mm. In addition, superheating of steam can be improved by applying a centrifugal compressor with cascade compression and centrifugal compression in conjunction with reflux adjustment at the compression outlet.