LAUSR

The appearance of cracks in brittle materials in general and in marble, in particular, is a problem in the hydro-abrasive jet cutting process. In this paper is presented a method to reduce the appearance of cracks when cutting with a hydro-abrasive jet of marble by using statistical analysis. The Taguchi method was used, establishing the main parameters that influence the process. Research design was based on performing experiments by modifying the parameters that influence the process. In this way, it has been shown that the stochastic effects resulting from the marble structure can be reduced. A careful study was made of the behavior of marble under the action of the hydro-abrasive jet, and of the behavior of the whole process in the processing of brittle materials. Results of experiments confirmed the hypothesis that statistical analysis is a procedure that can lead to a decrease in the number of cracks in processing. The measurement was performed with precise instruments and analyzed with recognized software and according to the results obtained, the reduction of the number of cracks is achieved through use of low pressure, a minimum stand-off distance and a small tube diameter. In this way, the paper presents a new and effective tool for optimizing the cutting with a hydro-abrasive jet of marble.