LAUSR

To achieve high-quality machining of the 2195 aluminum-lithium alloy, this paper presents an experimental study on the effect of milling processing parameters on milling forces and surface topography, during which conventional milling and longitudinal-torsional ultrasonic vibration milling of the 2195 Al-Li alloy were performed. The characterization of the tool tip trajectory illustrates some of the advantages of ultrasonic machining, which include variable depth of cut and tool chip pulling. The differences in milling forces between conventional milling and longitudinal-torsional ultrasonic vibration machining were compared using orthogonal tests, and the effect of ultrasonic vibration on milling forces was investigated in detail. The maximum reduction of milling force Fy in the feed direction under the influence of torsional vibration is 62% and 54% for larger feed per tooth and cutting depth, respectively. The high-frequency impact generated by the longitudinal vibration not only reduces the chip accumulation on the surface, but also smooths out the tool-tooth scratches and creates a regular surface profile. In addition, the characteristics of the milling force signals of the two machining methods were analyzed, and the analysis of the spectrum of the collected milling forces revealed that the ultrasonic vibration caused the high-frequency components of the milling forces Fy and Fz. The orthogonal result analysis and single-factor result analysis verified the superiority of ultrasonic machining, provided parameter selection for subsequent aluminum-lithium alloy machining, and bridged the gap of longitudinal torsional ultrasonic vibration machining of 2195 aluminum-lithium alloy in the study of milling force.