LAUSR

Industrial sludge continues to increase in quantity with the development of industry. Therefore, how to effectively treat industrial sludge continues to be an environmental focus around the world. Due to the high calorie content of industrial sludge in Taiwan, most of the sludge is incinerated for simplicity and convenience. However, this incineration causes environmental pollution and cannot effectively reuse the industrial sludge. In this study, we investigated the feasibility of lightweight aggregates produced from water treatment sludge (WTS) mixed with industrial sludge. The industrial sludge was obtained from three industrial zones in Taiwan. The lightweight aggregate materials were prepared by mixing WTS with 7.5%, 15.0%, or 22.5% of industrial sludge as a secondary ingredient. The chemical composition analyses revealed that the ternary phase diagrams of the chemical components were within the range recommended by C.M. Moreover, Riley indicated that the ingredients could expand. The sintering experiments were conducted in two stages. Stage I served to determine the optimal sintering temperature, while Stage II produced lightweight aggregates at the optimal sintering temperatures after 5, 10, or 15 min of preheating. The results indicated that an increase in preheating time increased the particle density of the lightweight aggregates but decreased the water absorption ratio, because increasing preheating time causes more gases to escape, resulting in aggregates that could not produce sufficient gas to support expansion during the sintering stage. The sintering results of the lightweight aggregates showed that their particle density was between 0.5 and 1.4 g/cm3, which met the requirements of the specification. Their water absorption rate was below 21%, which was roughly in line with the recommendations of the specification. When the amount of industrial sludge added was less than 22.5%, the lightweight aggregate was sintered successfully, which is suitable for engineering applications. The industrial sludge experienced a loss of between 50% and 70% on ignition, resulting in pores and cracks that were observed on the surfaces of the lightweight aggregate. Based on the energy required to sinter lightweight aggregates, a greater loss on ignition indicates the conversion of more materials into heat energy. Therefore, the use of industrial sludge in lightweight aggregates not only provides ways to reuse industrial sewage waste but also reduces the consumption requirements for sintering lightweight aggregates, thereby achieving energy-saving and carbon-reduction goals.