LAUSR

20Cr2Ni4A alloy is widely used in the manufacturing of heavy-duty gears, although limited information about its machinability during the form-grinding process has been reported. In this work, form-grinding trials on transmission gears of 20Cr2Ni4A alloy under various parameters were conducted. Surface morphology of the gear tooth, surface roughness distribution and microstructure evolution of the machined surface layer were comprehensively studied, and the influence of grinding parameters on grinding performance was investigated. The formation mechanisms of surface/subsurface defects during the form-grinding process, including plastic flow, deep grooves, successive crushing zone, adhesive chips and cavities, were analyzed. Results showed that the change in contact conditions between the grinding wheel and tooth surface led to the decrease in the surface roughness from tooth tip to root. Mechanical force and grinding heat promoted the deformation and refinement of the microstructure within the machined surface layer. With the increase in cutting depth and feed speed, the deformation ratio of the microstructure increased, which was also consistent with the variation trend in the form-grinding temperature.