LAUSR

The article presents the results of a study on metallurgical sludge reduction using electronic waste such as Printed Circuit Boards (PCBs). Two aspects were taken into account when selecting such a reducer, namely the environmental aspect and the technological aspect. The research was an attempt to use waste metal-bearing material of which the effective management causes many problems from an environmental point of view. In the technological aspect, the specific chemical composition of this waste was taken into account. Its gasification yields significant amounts of hydrocarbons, which are excellent reducing agents in such process. The separation of these compounds may additionally cause the mixing of the molten slag, which should result in faster separation of the formed metal droplets and the molten slag. In the case of the fragmented PCB (Printed Circuit Board) reducer used in this study, a significant degree of copper removal was achieved, as much as 92%. As the reduction-process time increased, the degree of copper removal also increased. For the 1 h process, the average value of copper removal was 60%, and for the 4.5 h process it was over 70%. The case was the same with the addition of reductant: as the amount of reductant added to the process increased, an increase in copper removal was observed. With the addition of 30 g of the reducing agent (per 65 g of slag), the degree of copper removal was over 90%.