Optimization of mechanical properties, biocorrosion properties and antibacterial properties of wrought Ti-3Cu alloy by heat treatment
Sign Up to like & getrecommendations! Published in 2018 at "Bioactive Materials"
DOI: 10.1016/j.bioactmat.2018.01.004
Abstract: Previous study has shown that Ti-3Cu alloy shows good antibacterial properties (>90% antibacterial rate), but the mechanical properties still need to be improved. In this paper, a series of heat-treatment processes were selected to adjust… read more here.
Keywords: heat treatment; antibacterial properties; treatment; mechanical properties ... See more keywords
Influence of deformation microstructure on the precipitation behaviors of an Al-4Mg-0.3Cu alloy
Sign Up to like & getrecommendations! Published in 2017 at "Journal of Alloys and Compounds"
DOI: 10.1016/j.jallcom.2016.11.073
Abstract: Abstract To provide insight into the effect of deformation microstructure on the precipitation behavior, an Al-4Mg-0.3Cu alloy was processed by high-pressure torsion followed by subsequent in-situ heating in a transmission electron microscope. Structural characterization revealed… read more here.
Keywords: precipitation; microstructure precipitation; deformation microstructure; precipitation behaviors ... See more keywords
Microstructure and Mechanical Properties of Al-4Mg-0.3Cu Alloy after HPT and Postdeformation Annealing
Sign Up to like & getrecommendations! Published in 2023 at "Metals"
DOI: 10.3390/met13040810
Abstract: The effects of different strain levels applied through high-pressure torsion (HPT) deformation following annealing on the microstructural evolution, thermal stability, and mechanical properties of Al-4Mg-0.3Cu alloy were investigated. The results reveal that Cu-segregated grain boundaries… read more here.
Keywords: 4mg 3cu; mechanical properties; hpt; 3cu alloy ... See more keywords
Mechanical Properties of Multi-Directional Forged Al-7Si-4Zn-3Cu Alloy
Sign Up to like & getrecommendations! Published in 2018 at "Defect and Diffusion Forum"
DOI: 10.4028/www.scientific.net/ddf.385.250
Abstract: In this study, Al-7Si-4Zn-3Cu alloy was processed by multi-directional forging (MDF) at 3, 6 and pass corresponding one, two and three cycle, respectively. The structural and mechanical properties of the alloys were investigated at as-cast,… read more here.
Keywords: multi directional; 4zn 3cu; mechanical properties; 7si 4zn ... See more keywords