Effect of hot isostatic pressing on the critical defect size distribution in AlSi7Mg0.6 alloy obtained by selective laser melting
Sign Up to like & getrecommendations! Published in 2020 at "International Journal of Fatigue"
DOI: 10.1016/j.ijfatigue.2020.105797
Abstract: Abstract This study focuses on the influence of defect density on the sizes of the critical defects responsible for fatigue failure in AlSi7Mg0.6 alloy produced by Selective Laser Melting. Samples having similar microstructures and different… read more here.
Keywords: selective laser; alsi7mg0 alloy; laser melting; isostatic pressing ... See more keywords
Effect of Alloy Additions on the Structure and Mechanical Properties of the AlSi7Mg0.3 Alloy
Sign Up to like & getrecommendations! Published in 2017 at "Archives of Foundry Engineering"
DOI: 10.1515/afe-2017-0025
Abstract: The study presents the results of the investigations of the effect of Cu, Ni, Cr, V, Mo and W alloy additions on the microstructure and mechanical properties of the AlSi7Mg0.3 alloy. The examinations were performed… read more here.
Keywords: alloy; alloy additions; alsi7mg0 alloy; properties alsi7mg0 ... See more keywords
Microstructural Characteristics of Al-Ti-B Inoculation Wires and Their Addition to the AlSi7Mg0.3 Alloy
Sign Up to like & getrecommendations! Published in 2022 at "Materials"
DOI: 10.3390/ma15217626
Abstract: Commercially supplied inoculation wires have a guaranteed chemical composition but not the size and distribution of individual phases, which are very important for nucleation. Therefore, two commercial alloys used for the inoculation of Al-Si alloys… read more here.
Keywords: microstructural characteristics; inoculation wires; alsi7mg0 alloy; inoculation ... See more keywords