Sign Up to like & get
recommendations!
0
Published in 2019 at "Additive Manufacturing"
DOI: 10.1016/j.addma.2019.06.004
Abstract: Abstract Poly(lactic acid) (PLA) and PLA grafted cellulose nanofibers (PLA-g-CNFs) mixture were extruded into filaments, and subsequently 3D printed into composites. As-3D printed composites were then thermally annealed at a temperature above PLA glass transition…
read more here.
Keywords:
poly lactic;
annealing treatment;
lactic acid;
pla ... See more keywords
Sign Up to like & get
recommendations!
0
Published in 2017 at "Applied Surface Science"
DOI: 10.1016/j.apsusc.2017.06.334
Abstract: Abstract In this work, a hierarchical Ni3S2@MoS2 hybrid structure was synthesized by an effective strategy with a combined hydrothermal route and subsequent annealing treatment. When tested as supercapacitor electrodes, the Ni3S2@MoS2 composites exhibited high specific…
read more here.
Keywords:
hybrid structure;
ni3s2 mos2;
annealing treatment;
capacitance ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
1
Published in 2018 at "Ceramics International"
DOI: 10.1016/j.ceramint.2018.08.305
Abstract: Abstract In this study, non-layered and well-crystallized Cu(In, Ga)Se2 (CIGS) films without Se deficiency were fabricated through annealing treatment for one-step preparation of CIGS films. The as-deposited films were simply fabricated via RF magnetron sputtering…
read more here.
Keywords:
magnetron sputtering;
annealing treatment;
ceramic target;
quaternary ceramic ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
0
Published in 2021 at "Ceramics International"
DOI: 10.1016/j.ceramint.2021.08.187
Abstract: Abstract Holmium doped BaTiO3 ceramics were prepared by a solid-state reaction. Colossal dielectric permittivity (≥105) and a very low loss tangent (
read more here.
Keywords:
annealing treatment;
modulation annealing;
compositional modulation;
permittivity ... See more keywords
Sign Up to like & get
recommendations!
0
Published in 2018 at "Journal of Alloys and Compounds"
DOI: 10.1016/j.jallcom.2018.01.136
Abstract: Abstract Nanocrystalline Ti/AZ61 magnesium matrix composite, prepared by mechanical milling, was annealed in the temperature range of 573–723 K for various durations. During annealing treatment, diffusion of Al and Ti elements, formation of precipitates and grain…
read more here.
Keywords:
evolution;
annealing treatment;
magnesium;
magnesium matrix ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
1
Published in 2020 at "Journal of Nuclear Materials"
DOI: 10.1016/j.jnucmat.2020.152530
Abstract: Abstract Ageing of Cast Austenitic Stainless Steels (CASS) was attributed to the decomposition of the ferrite by spinodal decomposition and precipitation of G-phase particles. This leads to an increase in hardness and a decrease in…
read more here.
Keywords:
cast austenitic;
stainless steels;
austenitic stainless;
annealing treatment ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
0
Published in 2018 at "Materials Characterization"
DOI: 10.1016/j.matchar.2018.03.036
Abstract: Abstract This research work is an attempt to understand the effect of stored strain energy heterogeneity over macro-scale, induced during interrupted annealing treatment, on the micro structural evolution in a heavily cold rolled AISI 304L…
read more here.
Keywords:
stored strain;
annealing treatment;
strain energy;
Sign Up to like & get
recommendations!
0
Published in 2018 at "Materials Characterization"
DOI: 10.1016/j.matchar.2018.04.056
Abstract: Abstract It is usually one of important goals to obtain the homogeneous microstructure for forgings by hot working, such as hot die forging. However, there is always a large inhomogeneous deformation in die forgings during…
read more here.
Keywords:
annealing treatment;
evolution typical;
microstructural evolution;
treatment ... See more keywords
Sign Up to like & get
recommendations!
1
Published in 2019 at "Optical Materials"
DOI: 10.1016/j.optmat.2019.03.015
Abstract: Abstract The one-dimensional structure TiO2/Bi2S3 composite films can be used as the photo-anode in the thin film solar cells. Due to its advantages of wide optical absorption range and relatively simpler fabrication progress, the composite…
read more here.
Keywords:
bi2s3 composite;
annealing treatment;
tio2 bi2s3;
composite film ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
1
Published in 2018 at "Solar Energy Materials and Solar Cells"
DOI: 10.1016/j.solmat.2018.08.006
Abstract: Abstract Sb2Se3 thin films prepared by vapor transport deposition (VTD) method have been treated by post annealing process at 200 °C in vacuum condition for 1 h, and the comparative studies between the post annealing treatment…
read more here.
Keywords:
sb2se3 thin;
annealing treatment;
treatment;
post annealing ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
0
Published in 2019 at "Surface and Coatings Technology"
DOI: 10.1016/j.surfcoat.2018.11.046
Abstract: Abstract Tungsten coatings were deposited onto oxygen-free copper substrate by atmospheric plasma spraying technique. Annealing treatment was adopted to modify the inherent defects and improve the performance of the plasma sprayed tungsten coating. The effect…
read more here.
Keywords:
sprayed tungsten;
annealing treatment;
tungsten coating;
plasma sprayed ... See more keywords