Articles with "based injection" as a keyword



Photo from wikipedia

Lime-based injection grouts with reduced water content: An assessment of the effects of the water-reducing agents ovalbumin and ethanol on the mineralogical evolution and properties of grouts

Sign Up to like & get
recommendations!
Published in 2017 at "Journal of Cultural Heritage"

DOI: 10.1016/j.culher.2017.10.003

Abstract: Abstract Non-structural lime-based injection grouts with reduced water content were designed for the stabilisation of delaminated plasters in water-sensitive contexts. Two water reducing components were considered: (i) ethanol, as a partial substitute for water, being… read more here.

Keywords: reduced water; water; lime based; based injection ... See more keywords
Photo from wikipedia

High-Resolution Dielectric Sensor Based on Injection-Locked Oscillators

Sign Up to like & get
recommendations!
Published in 2018 at "IEEE Sensors Journal"

DOI: 10.1109/jsen.2017.2772923

Abstract: The structure of a high-resolution microwave material sensor is presented based on the injection locking phenomenon. For a sample under test, the variation of center frequency and lock range of the oscillator with respect to… read more here.

Keywords: high resolution; frequency; based injection; injection ... See more keywords
Photo by hakannural from unsplash

Energy-Efficient Cyclic-Coupled Ring Oscillator With Delay-Based Injection Locking

Sign Up to like & get
recommendations!
Published in 2022 at "IEEE Transactions on Circuits and Systems II: Express Briefs"

DOI: 10.1109/tcsii.2022.3176805

Abstract: This brief presents a new tristate-based delay cell to realize the recently proposed delay-based injection locking in ring oscillators. The circuit is then applied to implement a cyclic-coupled ring oscillator (CCRO). Compared to an inverter-based… read more here.

Keywords: injection; circuit; injection locking; based injection ... See more keywords
Photo from wikipedia

A 3.2-GHz 178-fsrms Jitter Subsampling PLL/DLL-Based Injection-Locked Clock Multiplier

Sign Up to like & get
recommendations!
Published in 2022 at "IEEE Transactions on Very Large Scale Integration (VLSI) Systems"

DOI: 10.1109/tvlsi.2022.3169636

Abstract: This article proposes a 3.2-GHz subsampling phase-locked loop (SSPLL)-based injection-locked clock multiplier (ILCM) using a subsampling delay-locked loop (SSDLL). The proposed ILCM achieves a superior noise reduction effect at low offset frequency because of the… read more here.

Keywords: injection; injection locked; clock multiplier; based injection ... See more keywords