Effect of Cold‐Rolling Deformation on Texture Evolution and Tensile Properties of Titanium Foil for Hydrogen Fuel Cell
Sign Up to like & getrecommendations! Published in 2024 at "Advanced Engineering Materials"
DOI: 10.1002/adem.202400011
Abstract: Preparation of a titanium foil with weak anisotropy is of great significance for the development of bipolar plate materials for hydrogen fuel cell. However, the titanium foil obtained by rolling deformation often suffer from a… read more here.
Keywords: cold rolling; texture; deformation; hydrogen fuel ... See more keywords
High Strength and Low Yield Anisotropy of Hot‐Extruded Mg‐2.35Nd‐1.32Gd‐0.18Zn‐0.32Zr Alloy Sheet via Cold Rolling and Subsequent Aging Heat Treatment
Sign Up to like & getrecommendations! Published in 2025 at "Advanced Engineering Materials"
DOI: 10.1002/adem.202402569
Abstract: In the article, microstructure, texture, and room‐temperature mechanical properties of the hot‐extruded Mg‐2.35Nd‐1.32Gd‐0.18Zn‐0.32Zr alloy sheet subjected to cold rolling and subsequent aging heat treatment are investigated. It is found that the extruded experimental alloy sheet… read more here.
Keywords: aging heat; alloy sheet; subsequent aging; rolling subsequent ... See more keywords
Effect of Cr Addition and Different Processes on the Microstructure and Properties of Cu–Ag Alloys
Sign Up to like & getrecommendations! Published in 2025 at "Advanced Engineering Materials"
DOI: 10.1002/adem.202501215
Abstract: With the rapid development of high‐tech and manufacturing industries, higher mechanical properties and electrical conductivity requirements are required. Cu–5Ag, Cu–10Ag, Cu–5Ag–0.5Cr, and Cu–10Ag–0.5Cr (at.%) alloys are fabricated and investigated to achieve high strength and electrical… read more here.
Keywords: electrical conductivity; conductivity; high strength; cold rolling ... See more keywords
pH‐dependent lubrication mechanism of graphene oxide aqueous lubricants on the strip surface during cold rolling
Sign Up to like & getrecommendations! Published in 2020 at "Surface and Interface Analysis"
DOI: 10.1002/sia.6928
Abstract: The tribological performance and lubrication mechanism of graphene oxide (GO) aqueous lubricants with different pH levels on the strip surfaces during cold rolling were investigated. And triethanolamine (TEA) was used to adjust the pH levels… read more here.
Keywords: lubrication; mechanism graphene; surface; cold rolling ... See more keywords
Effect of the Deformation Amount on the Microstructure and Tensile Properties of 304 Stainless Steel with 2 wt% Al Content by Cold Rolling
Sign Up to like & getrecommendations! Published in 2020 at "steel research international"
DOI: 10.1002/srin.201900585
Abstract: The microstructure evolution during cold rolling and mechanical properties after solution treatment of 304 stainless steel with 2 wt% Al are investigated and the tensile properties of the steels are also tested. The results show that… read more here.
Keywords: tensile properties; steel; cold rolling; 304 stainless ... See more keywords
Ultra‐Thin 3.5%Si Steel with Both Magnetic Properties and Mechanical Properties Produced by Different Process Routes of Large‐Scale Production
Sign Up to like & getrecommendations! Published in 2024 at "steel research international"
DOI: 10.1002/srin.202400431
Abstract: The microstructural and textural evolution, as well as the recrystallization kinetics under different cold‐rolling methods and their influencing mechanism on the properties of the thin‐gauge 3.5%Si nonoriented silicon steel, are investigated by electron backscattering diffraction,… read more here.
Keywords: mechanical properties; process; steel; magnetic properties ... See more keywords
Effect of Cold Rolling and Molybdenum Content on the Kinetics of Spinodal Decomposition in Duplex Stainless Steels
Sign Up to like & getrecommendations! Published in 2025 at "steel research international"
DOI: 10.1002/srin.202500420
Abstract: This work analyzes the effects of cold rolling and aging treatment at 500 °C on duplex stainless steel 2205 and 2304 lean duplex stainless steel. Microstructural analyses are conducted using scanning electron microscopy, transmission electron microscopy,… read more here.
Keywords: duplex stainless; effect cold; decomposition; cold rolling ... See more keywords
Analysis of Hot- and Cold-Rolled Loads in Medium-Mn TRIP Steels
Sign Up to like & getrecommendations! Published in 2019 at "Metallurgical and Materials Transactions B"
DOI: 10.1007/s11663-019-01566-4
Abstract: The purpose of this work is to investigate the hot- and cold-rolling requirements to produce third-generation advanced high-strength steels (AHSS). Therefore, five medium-Mn (10 to 14 wt pct Mn) alloys that exhibit transformation-induced plasticity (TRIP) were… read more here.
Keywords: hot cold; trip; cold rolling; trip steels ... See more keywords
The Evolution of Second-Phase Particles in 6111 Aluminum Alloy Processed by Hot and Cold Rolling
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Materials Engineering and Performance"
DOI: 10.1007/s11665-018-3194-0
Abstract: The evolution of coarse Al9.9Fe2.65Ni1.45 phase, spherical Al12(Mn,Fe)3Si phase and rod-like Q phase in a 6111 aluminum alloy during hot and cold rolling deformation processes was systematically investigated in this work. The results showed that… read more here.
Keywords: hot cold; phase; aluminum alloy; evolution ... See more keywords
Recrystallization Behavior and Super-Elasticity of a Metastable β-Type Ti-21Nb-7Mo-4Sn Alloy During Cold Rolling and Annealing
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Materials Engineering and Performance"
DOI: 10.1007/s11665-018-3476-6
Abstract: Based on the d-electron alloy design theory, a new metastable β-type titanium alloy for biomedical applications, Ti-21Nb-7Mo-4Sn (wt.%) was designed in this article. This theory predicted this alloy was a metastable single β-type titanium alloy… read more here.
Keywords: alloy; metastable type; cold rolling; alloy cold ... See more keywords
Effect of Pre-cold Rolling-Induced Twins and Subsequent Precipitated ω-Phase on Mechanical Properties in a β-Type Ti–Mo Alloy
Sign Up to like & getrecommendations! Published in 2017 at "Acta Metallurgica Sinica (English Letters)"
DOI: 10.1007/s40195-017-0687-z
Abstract: This paper reported an effectiveness of pre-cold rolling-induced {332} twins combined with subsequent isothermal ω-phase formation for enhancement of uniform elongation in a β-type Ti–15Mo alloy with high yield strength level. Mechanical {332} twins were induced by… read more here.
Keywords: phase; induced twins; cold rolling; rolling induced ... See more keywords