Articles with "conventional sintering" as a keyword



Photo from wikipedia

Mechanical and Tribological Properties of Alumina Toughened Zirconia Composites through Conventional Sintering and Microwave Sintering

Sign Up to like & get
recommendations!
Published in 2020 at "Transactions of the Indian Institute of Metals"

DOI: 10.1007/s12666-020-02001-y

Abstract: The present study investigates the relative density, mechanical and tribological properties of 3 mol% yttria-stabilized zirconia composites reinforced with 10 vol% of alumna through both conventional sintering and microwave sintering (CS and MW). The variations in… read more here.

Keywords: tribological properties; mechanical tribological; sintering microwave; conventional sintering ... See more keywords
Photo from wikipedia

Development of Al2O3 electrospun fibers prepared by conventional sintering method or plasma assisted surface calcination

Sign Up to like & get
recommendations!
Published in 2017 at "Applied Surface Science"

DOI: 10.1016/j.apsusc.2016.11.162

Abstract: In this paper, the electrospinning method was used for preparation of aplha-Al2O3 microfibersfrom PAN/Al(NO3)3 precursor solution. The precursor fibers were thermally treated by conventional method in furnace or low-temperature plasma induced surface sintering method in… read more here.

Keywords: sintering method; plasma; al2o3; surface ... See more keywords
Photo from wikipedia

A comparison of power controlled flash sintering and conventional sintering of strontium titanate

Sign Up to like & get
recommendations!
Published in 2017 at "Scripta Materialia"

DOI: 10.1016/j.scriptamat.2016.12.008

Abstract: Abstract The microstructural evolution of SrTiO 3 is analyzed during power controlled flash sintering. A controllable sintering process is achieved by lowering the specific power densities yielding a relatively slow flash sintering. The analytical equations… read more here.

Keywords: controlled flash; conventional sintering; power controlled; power ... See more keywords
Photo from wikipedia

Microwave versus Conventional Sintering of NiTi Alloys Processed by Mechanical Alloying

Sign Up to like & get
recommendations!
Published in 2022 at "Materials"

DOI: 10.3390/ma15165506

Abstract: The present study shows a comparison between two sintering processes, microwave and conventional sintering, for the manufacture of NiTi porous specimens starting from powder mixtures of nickel and titanium hydrogenation–dehydrogenation (HDH) milled by mechanical alloying… read more here.

Keywords: versus conventional; mechanical alloying; conventional sintering; microwave versus ... See more keywords