Substructure of deformation zones in austempered ductile iron finish-turning chips
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Materials Processing Technology"
DOI: 10.1016/j.jmatprotec.2018.07.019
Abstract: Abstract A series of dry finish-turning tests of a structural austempered ductile iron with PcBN cutting-inserts were run with a depth of cut of 200 μm, a feed-rate of 50 μm rev −1 and a cutting length of… read more here.
Keywords: deformation zones; substructure; deformation; finish turning ... See more keywords
Tool wear characterizations in finish turning of AISI 1045 carbon steel for MQCL conditions
Sign Up to like & getrecommendations! Published in 2017 at "Wear"
DOI: 10.1016/j.wear.2016.12.006
Abstract: Abstract This study presents analysis of tool wear of P25 cemented carbide inserts in finish turning of AISI 1045 carbon steel for different cooling conditions: dry cutting, minimum quantity cooling-lubrication (MQCL) and MQCL with phosphate… read more here.
Keywords: mqcl; turning aisi; finish turning; tool wear ... See more keywords
Investigation of the Influence of Anti-Wear Coatings on the Surface Quality and Dimensional Accuracy during Finish Turning of the Inconel 718 Alloy
Sign Up to like & getrecommendations! Published in 2023 at "Materials"
DOI: 10.3390/ma16020715
Abstract: This piece of work deals with the influence assessment of the kind of coating of the cutting inserts and their wear on the dimensional accuracy and the top layer microstructure and roughness of the surface… read more here.
Keywords: finish turning; dimensional accuracy; accuracy; surface quality ... See more keywords
The Use of Graphite Micropowder in the Finish Turning of the Ti-6Al-4V Titanium Alloy Under Minimum Quantity Lubrication Conditions
Sign Up to like & getrecommendations! Published in 2024 at "Materials"
DOI: 10.3390/ma17246121
Abstract: The use of the minimum quantity lubrication (MQL) method during machining leads to the reduced consumption of cooling and lubricating liquids, thus contributing to sustainable machining. To improve the properties of liquids used under MQL… read more here.
Keywords: graphite micropowder; minimum quantity; quantity lubrication; micropowder ... See more keywords
An Insight into Chip and Surface Texture Shaping Under Finish Turning of Powder Steels Infiltrated with Tin Bronze
Sign Up to like & getrecommendations! Published in 2024 at "Materials"
DOI: 10.3390/ma17246244
Abstract: The manufacturing of work parts made of powder (sintered) steels is currently widespread in industry, as it provides minimal processing allowances and high dimensional accuracy, as well as the required properties and unconventional chemical composition.… read more here.
Keywords: powder steels; initial state; powder; finish turning ... See more keywords