Sign Up to like & get
recommendations!
1
Published in 2019 at "Food Hydrocolloids"
DOI: 10.1016/j.foodhyd.2018.10.002
Abstract: Abstract Spray drying-based microencapsulation has been applied to mask unpleasant odours and to protect bioactives in liquid based products. However, little research has been undertaken to explore how particle formation occurs during the drying process…
read more here.
Keywords:
structure formation;
formation;
droplet;
particle ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
1
Published in 2020 at "Surfaces and Interfaces"
DOI: 10.1016/j.surfin.2020.100801
Abstract: Abstract The sorption-diffusion method was used to obtain nonstoichiometric copper sulfide layers on polypropylene. Copper sulfide layers consisted of monoclinic structures chalcocite Cu2S and djurleite Cu1.8S. This multiphase composition of obtained thin layers was confirmed…
read more here.
Keywords:
formation properties;
copper sulfide;
layers polypropylene;
copper ... See more keywords
Sign Up to like & get
recommendations!
1
Published in 2017 at "RSC Advances"
DOI: 10.1039/c7ra02737k
Abstract: Herein, we report a facile strategy to prepare a novel HMX-based microspheres by coating a layer of energetic binders on HMX. HMX-based microspheres were synthesized and compared by different dissolution methods by spray dying. The…
read more here.
Keywords:
formation properties;
hmx based;
based microspheres;
spray drying ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
0
Published in 2021 at "Applied Biochemistry and Microbiology"
DOI: 10.1134/s0003683821050069
Abstract: It has been shown that the Aspergillus flavus O-1 micromycete secretes a complex of at least two proteolytic enzymes. The most active enzyme was isolated via preparative isoelectric focusing and characterized as a serine proteinase…
read more here.
Keywords:
formation properties;
properties extracellular;
proteinase;
flavus micromycete ... See more keywords
Sign Up to like & get
recommendations!
1
Published in 2018 at "Advances in Materials Science and Engineering"
DOI: 10.1155/2018/2085368
Abstract: The nanocrystalline tantalum-ceramic composites were made using mechanical alloying followed by pulse plasma sintering (PPS). The tantalum acts as a matrix, to which the ceramic reinforced phase in the concentration of 5, 10, 20, and…
read more here.
Keywords:
formation properties;
properties y2o3;
tac nanocomposites;
grain size ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
1
Published in 2023 at "International Journal of Molecular Sciences"
DOI: 10.3390/ijms24010742
Abstract: The formation of oxide semiconductor films of the (Mn,Co,Cu)3O4 type by radio frequency magnetron sputtering is presented. The conditions of deposition and subsequent heat treatment make it possible to obtain films with electrophysical characteristics close…
read more here.
Keywords:
semiconductor;
geometry;
formation properties;
magnetron sputtering ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
0
Published in 2017 at "Materials"
DOI: 10.3390/ma10080933
Abstract: The formation and properties of laser-induced periodic surface structures (LIPSS) was investigated on different technically relevant glasses including fused silica, borosilicate glass, and soda-lime-silicate glass under irradiation of fs-laser pulses characterized by a pulse duration…
read more here.
Keywords:
formation properties;
microscopy;
formation;
surface structures ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
1
Published in 2022 at "Materials"
DOI: 10.3390/ma15114026
Abstract: Point defects are crucial in determining the quality of germanium crystals. A quantitative understanding of the thermodynamic formation properties of the point defects is necessary for the subsequent control of the defect formation during crystal…
read more here.
Keywords:
defects germanium;
thermodynamic formation;
point defects;
formation properties ... See more keywords
Photo from wikipedia
Sign Up to like & get
recommendations!
1
Published in 2022 at "Polymers"
DOI: 10.3390/polym14020261
Abstract: A new dietherpyrene-cored diamine monomer, namely, 4,5-bis(4-aminophenoxy)pyrene, was successful synthesized and formed a series of electroactive polyamides with an aryloxy linkage in a polymer main chain and bearing pyrene chromophore as a pendent group using…
read more here.
Keywords:
formation properties;
properties electroactive;
synthesis excimer;
electroactive polyamides ... See more keywords