Effect of blast furnace slag content on mechanical and slurry abrasion behavior of needle‐punched nonwoven fabric reinforced epoxy composites
Sign Up to like & getrecommendations! Published in 2018 at "Advances in Polymer Technology"
DOI: 10.1002/adv.21835
Abstract: This article reports on mechanical and slurry abrasion response of a new class of material developed by reinforcement of blast furnace slag (BFS) in needle-punched nonwoven polyester fabric epoxy composites. These epoxy-based composites are prepared… read more here.
Keywords: slurry abrasion; furnace slag; needle punched; mechanical slurry ... See more keywords
Experimental investigation on sludge dewatering using granulated blast furnace slag as skeleton material
Sign Up to like & getrecommendations! Published in 2020 at "Environmental Science and Pollution Research"
DOI: 10.1007/s11356-020-07614-w
Abstract: The highly compressible nature of sludge and the presence of colloidal particles cause difficulties in sludge dewatering. Reducing the moisture content in secondary sludge is a key factor in reducing the capital costs, operational costs,… read more here.
Keywords: furnace slag; granulated blast; sludge; sludge dewatering ... See more keywords
Electrosynthesis of Ti5Si3, Ti5Si3/TiC, and Ti5Si3/Ti3SiC2 from Ti-Bearing Blast Furnace Slag in Molten CaCl2
Sign Up to like & getrecommendations! Published in 2018 at "Metallurgical and Materials Transactions B"
DOI: 10.1007/s11663-018-1192-0
Abstract: Ti5Si3, Ti5Si3/TiC, and Ti5Si3/Ti3SiC2 have been electrochemically synthesized from the Ti-bearing blast furnace slag/TiO2 and/or C mixture precursors at a cell voltage of 3.8 V and 1223 K to 1273 K (950 °C to 1000 °C) in molten CaCl2.… read more here.
Keywords: furnace slag; ti5si3 tic; ti3sic2; ti5si3 ... See more keywords
Effect of content of Al2O3 and MgO on crystallization of blast furnace slag during fiber formation
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Central South University"
DOI: 10.1007/s11771-018-3921-6
Abstract: The simulation of blast furnace slag was prepared by pure chemical reagents. Test methods like DSC, XRD and SEM were used to study the effect of Al2O3 and MgO content on crystallization of blast furnace… read more here.
Keywords: mgo; furnace slag; al2o3 mgo; crystallization ... See more keywords
Blast Furnace Slag Addition Effects on Delayed Ettringite Formation in Heat-cured Mortars
Sign Up to like & getrecommendations! Published in 2018 at "KSCE Journal of Civil Engineering"
DOI: 10.1007/s12205-017-0642-6
Abstract: Reducing expansion due to Delayed Ettringite Formation (DEF) is becoming an important issue that must be taken into account, when producing heat-cured concrete. Mineral additives used as partial cement replacement should help in achieving the… read more here.
Keywords: delayed ettringite; ettringite formation; blast furnace; furnace slag ... See more keywords
Determination of dielectric properties of titanium carbide fabricated by microwave synthesis with Ti-bearing blast furnace slag
Sign Up to like & getrecommendations! Published in 2020 at "International Journal of Minerals, Metallurgy and Materials"
DOI: 10.1007/s12613-020-1985-4
Abstract: The preparation of functional material titanium carbide by the carbothermal reduction of Ti-bearing blast furnace slag with microwave heating is an effective method for valuable metals recovery; it can alleviate the environmental pressure caused by… read more here.
Keywords: blast furnace; furnace slag; bearing blast;
Viscosity of Industrial Blast Furnace Slag in Indian Scenario
Sign Up to like & getrecommendations! Published in 2017 at "Transactions of the Indian Institute of Metals"
DOI: 10.1007/s12666-017-1212-9
Abstract: Twenty-five numbers of blast furnace slag samples are collected from different operational Indian blast furnaces. The viscosities of these slag samples are estimated using various models developed by several researchers for the purpose. Subsequently, viscosities… read more here.
Keywords: slag; viscosity; furnace slag; blast furnace ... See more keywords
Recycling Ladle Furnace Slag as Flux in Steelmaking: A Review
Sign Up to like & getrecommendations! Published in 2019 at "Journal of Sustainable Metallurgy"
DOI: 10.1007/s40831-019-00243-9
Abstract: The use of synthetic fluxes in secondary steelmaking not only improves the properties of top slag and steel quality but also increases the production cost. Ladle furnace (LF) slag can be used as a replacement… read more here.
Keywords: slag; ladle furnace; furnace slag; flux steelmaking ... See more keywords
The Resistance of Blast Furnace Slag- and Ferrochrome Slag-Based Geopolymer Concrete Against Acid Attack
Sign Up to like & getrecommendations! Published in 2019 at "International Journal of Civil Engineering"
DOI: 10.1007/s40999-019-00425-2
Abstract: In this study, blast furnace slag- (BFS) and Elazığ ferrochrome slag (EFS)-based geopolymer concretes were produced. Samples were immersed in 5% phosphoric acid (H3PO4), hydrochloric acid (HCl), hydrofluoric acid (HF) and sulfuric acid (H2SO4) solutions… read more here.
Keywords: furnace slag; slag; ferrochrome slag; based geopolymer ... See more keywords
Effect of metakaolin replaced granulated blast furnace slag on fresh and early strength properties of geopolymer mortar
Sign Up to like & getrecommendations! Published in 2018 at "Ain Shams Engineering Journal"
DOI: 10.1016/j.asej.2016.11.011
Abstract: Abstract We report the effect of metakaolin (MK) substituted granulated blast furnace slag (GBFS) on the early strength of geopolymer mortars (GPMs) for potential repair applications. Such GPMs were prepared by activating MK (0–15%) replaced… read more here.
Keywords: strength; furnace slag; granulated blast; effect metakaolin ... See more keywords
The study of properties and behavior of self compacting concrete containing Electric Arc Furnace Slag (EAFS) as aggregate
Sign Up to like & getrecommendations! Published in 2020 at "Ain Shams Engineering Journal"
DOI: 10.1016/j.asej.2019.10.001
Abstract: Abstract Electric Arc Furnace Slag (EAFS) can be efficiently reused as aggregate in the production of high-volume batches of hydraulic concrete mixes that show interesting properties in both the fresh and the hardened state. Mixtures… read more here.
Keywords: furnace slag; electric arc; eafs aggregate; slag eafs ... See more keywords