LAUSR

About LAUSR
Donate
Contact Us

Follow us:

You are not signed in:

Sign Up!


   Articles with "kerf width" as a keyword



Photo from wikipedia

Surface quality and kerf width prediction in abrasive water jet machining of metal-composite stacks

Sign Up to like & get
recommendations! Published in 2019 at "Composites Part B: Engineering"

DOI: 10.1016/j.compositesb.2019.107134

Abstract: Abstract Machinability of stacked Titanium (Ti6Al4V) and CFRP was evaluated using Abrasive Water Jet (AWJ) machining process. The experimental study was conducted using three pressure levels – 200, 275 and 350 MPa. Traverse speed was varied… read more here.

Keywords: jet; kerf width; abrasive water; water jet ... See more keywords
Photo from wikipedia

Experimental and parametric evaluation of cut quality characteristics in CO2 laser cutting of polystyrene

Sign Up to like & get
recommendations! Published in 2019 at "Optik"

DOI: 10.1016/j.ijleo.2019.03.040

Abstract: Abstract Cutting characteristics such as heat affected zone (HAZ), top and bottom kerf widths, ratio of top kerf width to bottom kerf width, and dross height are so reliant on process condition in the laser… read more here.

Keywords: co2 laser; kerf width; laser cutting; laser power ... See more keywords

Investigating error in saw mark minimum kerf width measurements

Sign Up to like & get
recommendations! Published in 2022 at "Journal of Forensic Sciences"

DOI: 10.1111/1556-4029.15178

Abstract: Minimum kerf width (MKW) is often assessed in medicolegal cases of skeletal sharp force trauma and can provide information about the tool used. Previously published saw MKW research focuses on the relationship between MKW and… read more here.

Keywords: kerf width; error; caliper; minimum kerf ... See more keywords

Influence of reduced graphene oxide addition on kerf width in abrasive water jet machining of nanofiller added epoxy-glass fibre composite

Sign Up to like & get
recommendations! Published in 2022 at "PLoS ONE"

DOI: 10.1371/journal.pone.0270505

Abstract: The present study aims to develop a novel hybrid polymer composite with reduced graphene oxide (rGO) as filler and optimize its Abrasive Water Jet Machining (AWJM) parameters for reduced kerf width. The influence of rGO… read more here.

Keywords: kerf width; addition; rgo; influence ... See more keywords

Prediction of Kerf Width and Surface Roughness of Al6351 Based Composite in Wire-Cut Electric Discharge Machining Using Mathematical Modelling

Sign Up to like & get
recommendations! Published in 2022 at "Materials"

DOI: 10.3390/ma15031102

Abstract: The machining of composite materials has been an area of intense research for the past couple of decades due to its wide range of applications, from automobiles to air crafts or from boats to nuclear… read more here.

Keywords: surface roughness; electric discharge; kerf width; width surface ... See more keywords