Sign Up to like & get
recommendations!
0
Published in 2017 at "Ceramics International"
DOI: 10.1016/j.ceramint.2016.12.120
Abstract: Abstract Nanorods of lanthanum phosphate obtained by a wet chemical precipitation route were granulated to obtain sizes in the range of 10–15 µm by spray drying from aqueous slurry of 35 wt% solid loading and 2 wt% of…
read more here.
Keywords:
plasma;
spray;
spray granulation;
lanthanum phosphate ... See more keywords
Sign Up to like & get
recommendations!
0
Published in 2020 at "Chemosphere"
DOI: 10.1016/j.chemosphere.2020.126551
Abstract: This work reports the synthesis of a new adsorbent material (LaP-POT), synthesised by sol-gel polymerisation method from lanthanum phosphate (LaP) and poly o-toluidine (POT). The sustainability and selectivity of the material as a potential adsorbent…
read more here.
Keywords:
pot;
lanthanum phosphate;
fluoride;
lap pot ... See more keywords
Sign Up to like & get
recommendations!
1
Published in 2019 at "Journal of Alloys and Compounds"
DOI: 10.1016/j.jallcom.2019.01.121
Abstract: Abstract A lanthanum based phosphate coating on magnesium AZ31 alloy was prepared through chemical conversion coating technique and characterized their corrosion performance. The coating was obtained in a two stage procedure using two different solvents,…
read more here.
Keywords:
phosphate;
az31 alloy;
spectroscopy;
chemical conversion ... See more keywords
Sign Up to like & get
recommendations!
0
Published in 2018 at "Journal of environmental chemical engineering"
DOI: 10.1016/j.jece.2018.02.013
Abstract: Abstract Neodymium–iron and samarium–cobalt–iron–copper alloys are typically used to produce magnets. As neodymium and samarium are rare earth elements, they are precious and expensive; consequently, they are often recovered by recycling processes to reduce costs.…
read more here.
Keywords:
lanthanum phosphate;
rare earth;
copper;
lanthanum ... See more keywords
Sign Up to like & get
recommendations!
0
Published in 2019 at "Measurement"
DOI: 10.1016/j.measurement.2018.09.009
Abstract: Abstract The machining property of Lanthanum phosphate/Yttria prepared by the aqueous sol-gel process is evaluated using abrasive waterjet machine. Jet pressure, Stand-off distance, and traverse speed are taken as the governing parameters on material removal…
read more here.
Keywords:
methodology;
surface;
abrasive waterjet;
response surface ... See more keywords