Hydrodynamics of a gas‐driven inverse liquid‐solid fluidized bed
Sign Up to like & getrecommendations! Published in 2020 at "Canadian Journal of Chemical Engineering"
DOI: 10.1002/cjce.23902
Abstract: ............................................................................................................................... i Co-Authorship Statement.................................................................................................... ii Acknowledgments.............................................................................................................. iii Table of read more here.
Keywords: hydrodynamics; inverse liquid; liquid solid; driven inverse ... See more keywords
A New Reversible Thermosensitive Liquid-Solid TENG Based on a P(NIPAM-MMA) Copolymer for Triboelectricity Regulation and Temperature Monitoring.
Sign Up to like & getrecommendations! Published in 2022 at "Small"
DOI: 10.1002/smll.202201442
Abstract: Intelligent and highly precise control of liquid-solid triboelectricity is of great significance for energy collection and electrostatic prevention. However, most of the traditional methods are irreversible and complex, greatly limiting their applicability. Here, a reversible… read more here.
Keywords: reversible thermosensitive; pnm; liquid solid; temperature ... See more keywords
In situ study on liquid structure of Sn during Sn/Cu liquid–solid interfacial reaction by fluorescence XAFS
Sign Up to like & getrecommendations! Published in 2017 at "Journal of Materials Science: Materials in Electronics"
DOI: 10.1007/s10854-017-6610-6
Abstract: Fluorescence X-ray Absorption Fine Structure (XAFS) was used to in situ study the local structure around Cu atoms in liquid Sn solder during Sn/Cu liquid–solid interfacial reaction. The extended edge data were analyzed by cumulant… read more here.
Keywords: liquid; liquid solid; solid interfacial; structure ... See more keywords
Preparation of chlorosulfonated polyethylene by liquid-solid method and comparison with industrial products
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Polymer Research"
DOI: 10.1007/s10965-018-1624-1
Abstract: The examination of chlorosulfonated polyethylene (CSM) prepared by a liquid-solid bulk reaction with sulfonyl chloride (SO2Cl2) is presented in this article. The basic structure of liquid-solid method CSM was compared with FT-IR and 1H-NMR. The… read more here.
Keywords: chlorosulfonated polyethylene; csm; method; solid method ... See more keywords
A microscopic and quantitative analysis on the separation of chloride ion by fly ash washing: Effect of liquid-to-solid ratio, washing time and temperature
Sign Up to like & getrecommendations! Published in 2022 at "Environmental Science and Pollution Research"
DOI: 10.1007/s11356-021-18390-6
Abstract: In order to understand the removal characteristics of Cl− (chloride ion) in the fly ash from municipal solid waste incineration, so as to realize the harmless treatment of fly ash. The fly ash washing treatment… read more here.
Keywords: time; liquid solid; fly ash; ash washing ... See more keywords
Influence of Zn Concentration on Interfacial Intermetallics During Liquid and Solid State Reaction of Hypo and Hypereutectic Sn-Zn Solder Alloys
Sign Up to like & getrecommendations! Published in 2019 at "Journal of Electronic Materials"
DOI: 10.1007/s11664-019-06941-0
Abstract: In this study, Sn-Zn solder samples containing 2 to 12 wt.% Zn were fabricated and reflowed into a Cu substrate. The microstructure of solder samples was observed after reflow and aging for up to 1000 h at… read more here.
Keywords: interfacial intermetallics; concentration interfacial; liquid solid; solder ... See more keywords
Phenolic compound extraction from spent coffee grounds for antioxidant recovery
Sign Up to like & getrecommendations! Published in 2019 at "Korean Journal of Chemical Engineering"
DOI: 10.1007/s11814-018-0208-4
Abstract: As the popularity of coffee beverage increases, an upsurge in the amount of solid residue, known as spent coffee ground (SCG), is inevitable. Currently, SCG is disposed of in the form of solid waste. However,… read more here.
Keywords: extraction; spent coffee; extraction time; liquid solid ... See more keywords
Mass exchange at liquid-solid interface: a molecular simulation scheme applied to evaporation phenomena
Sign Up to like & getrecommendations! Published in 2020 at "Journal of Mechanical Science and Technology"
DOI: 10.1007/s12206-020-0836-6
Abstract: A numerical technique is presented that enables mass exchange at the liquid-solid interface region in a molecular simulation. Particles can be inserted and deleted in the solid region where interaction between the fluid and solid… read more here.
Keywords: exchange liquid; mass exchange; evaporation; liquid solid ... See more keywords
Simulation of particulate matter movement characteristics in multiphase flow field system
Sign Up to like & getrecommendations! Published in 2021 at "Journal of Mechanical Science and Technology"
DOI: 10.1007/s12206-021-0720-z
Abstract: An innovative separation system based on dielectric electrophoresis (DEP-on-a-chip system) is proposed to separate different particulate matters. A discrete phase model (DPM) and coupling model was utilized to simulate the movement characteristics in liquid-solid two… read more here.
Keywords: system; movement; liquid solid; movement characteristics ... See more keywords
Vapor-liquid-solid-like growth of thin film SiC by nanoscale alternating deposition of SiC and NiSi2
Sign Up to like & getrecommendations! Published in 2020 at "Applied Surface Science"
DOI: 10.1016/j.apsusc.2020.147153
Abstract: Abstract We propose a vapour-liquid-solid (VLS)-like growth by alternately depositing nanoscale precursors of film and liquid flux using a pulsed laser deposition system with rapid beam deflection (RBD-PLD). The nanoscale alternating deposition of NiSi2 and SiC… read more here.
Keywords: liquid; deposition; liquid solid; film ... See more keywords
Numerical simulation of flow behavior of particles in a liquid-solid stirred vessel with baffles
Sign Up to like & getrecommendations! Published in 2017 at "Advanced Powder Technology"
DOI: 10.1016/j.apt.2017.04.004
Abstract: Abstract Flow behavior of particles is simulated by means of two-fluid model combining with kinetic theory of granular flow in a liquid-solid stirred vessel with baffles. The Huilin-Gidaspow drag model is used to obtain interphase… read more here.
Keywords: stirred vessel; flow behavior; solid stirred; liquid solid ... See more keywords