Experimental Approach to Determine Damage Curves for SnAgCu Solder Under Sequential Cyclic Loads
Sign Up to like & getrecommendations! Published in 2019 at "Journal of Electronic Materials"
DOI: 10.1007/s11664-019-07811-5
Abstract: Miner’s rule assumes that damage in solder interconnects accumulates linearly under cyclic loading and is independent of the load sequence. Under these constraints, damage is equivalent to cycle ratio, defined as the ratio of the… read more here.
Keywords: load dependent; experimental approach; solder; damage ... See more keywords
Investigation of load-dependent heat of adsorption of alkanes and alkenes on zeolites and activated carbon
Sign Up to like & getrecommendations! Published in 2017 at "Microporous and Mesoporous Materials"
DOI: 10.1016/j.micromeso.2016.12.037
Abstract: Abstract To investigate the load-dependent heat of adsorption a sensor gas calorimeter was developed which allows the simultaneous measurement of adsorption capacity and heat of adsorption in porous materials. A commercially available volumetric measurement device… read more here.
Keywords: load dependent; adsorption; dependent heat; heat adsorption ... See more keywords
A load-dependent PWA-H∞ controller for semi-active suspensions to exploit the performance of MR dampers
Sign Up to like & getrecommendations! Published in 2019 at "Mechanical Systems and Signal Processing"
DOI: 10.1016/j.ymssp.2019.03.018
Abstract: Abstract Magnetorheological (MR) dampers enable wide-range adjustment of damping and are considered as promising actuators for suspension performance optimization. However, MR dampers also exhibit complex nonlinearities, including hysteresis and bi-viscosity. Moreover, in addition to handling… read more here.
Keywords: semi active; performance; pwa controller; controller ... See more keywords
Load-Dependent Soft-Switching Method of Half-Bridge Current Doubler for High-Voltage Point-of-Load Converter in Data Center Power Supplies
Sign Up to like & getrecommendations! Published in 2017 at "IEEE Transactions on Power Electronics"
DOI: 10.1109/tpel.2016.2580603
Abstract: With the increased cloud computing and digital information storage, the energy requirement of data centers keeps increasing. A high-voltage point of load (HV POL) with an input series output parallel structure is proposed to convert… read more here.
Keywords: load dependent; half bridge; method;
The role of a cytoplasmic loop of MotA in load‐dependent assembly and disassembly dynamics of the MotA/B stator complex in the bacterial flagellar motor
Sign Up to like & getrecommendations! Published in 2017 at "Molecular Microbiology"
DOI: 10.1111/mmi.13843
Abstract: The proton‐driven flagellar motor of Salmonella enterica can accommodate a dozen MotA/B stators in a load‐dependent manner. The C‐terminal periplasmic domain of MotB acts as a structural switch to regulate the number of active stators… read more here.
Keywords: flagellar motor; load dependent; assembly; stator ... See more keywords
A Modified Prandtl-Ishlinskii Hysteresis Modeling Method with Load-dependent Delay for Characterizing Magnetostrictive Actuated Systems
Sign Up to like & getrecommendations! Published in 2018 at "Mechanical Sciences"
DOI: 10.5194/ms-9-177-2018
Abstract: Abstract. The actuating precision of a micro-positioning system, driven by a magnetostrictive actuator, is adversely limited by its nonlinearities, particularly the output-input hysteresis, which are further affected by the operating load and input frequency. In… read more here.
Keywords: magnetostrictive actuated; hysteresis; prandtl ishlinskii; load dependent ... See more keywords