Articles with "modified model" as a keyword



Photo from wikipedia

Using Response Surface Methodology and providing a modified model using whale algorithm for estimating the compressive strength of columns confined with FRP sheets

Sign Up to like & get
recommendations!
Published in 2018 at "Construction and Building Materials"

DOI: 10.1016/j.conbuildmat.2018.06.081

Abstract: Abstract This study presented a modified model for determining the compressive strength of square and rectangular concrete columns using whale algorithm and a widespread database. In this model, the effective strain coefficient of FRP and… read more here.

Keywords: methodology; modified model; using whale; model ... See more keywords
Photo by kellysikkema from unsplash

Numerical study of the dehumidification structure optimization based on the modified model

Sign Up to like & get
recommendations!
Published in 2019 at "Energy Conversion and Management"

DOI: 10.1016/j.enconman.2018.12.001

Abstract: Abstract Nowadays, the vast majority of electricity is extracted from the steam turbine, while the non-equilibrium condensation will take place because of the high steam velocity and low superheat temperature in steam low-pressure stage, which… read more here.

Keywords: dehumidification; non equilibrium; outlet; modified model ... See more keywords
Photo from wikipedia

A modified Marciniak–Kuczynski model for determining the forming limit of thin-walled tube extruded with initial eccentricity

Sign Up to like & get
recommendations!
Published in 2019 at "International Journal of Mechanical Sciences"

DOI: 10.1016/j.ijmecsci.2018.12.029

Abstract: Abstract Thickness deviation in hoop direction is often observed in thin-walled extruded tubes, which is mainly due to the eccentric position of extrusion mandrel. This imperfection in thickness may result in different deformation pattern and… read more here.

Keywords: model; hydro bulging; modified model; eccentricity ... See more keywords
Photo by alberthyseni from unsplash

New Modified Model for Estimating the Peak Shear Strength of Rock Mass Containing Nonconsecutive Joint Based on a Simulated Experiment

Sign Up to like & get
recommendations!
Published in 2020 at "International Journal of Geomechanics"

DOI: 10.1061/(asce)gm.1943-5622.0001732

Abstract: Abstract In the Jennings criterion, which is commonly used to estimate the shear strength of nonconsecutive jointed rock masses, the estimated values deviate from the actual values due to the crite... read more here.

Keywords: strength; shear strength; new modified; modified model ... See more keywords
Photo from wikipedia

A modified model of surface temperature inversion based on Landsat 8 remote-sensing data and measured data

Sign Up to like & get
recommendations!
Published in 2018 at "International Journal of Remote Sensing"

DOI: 10.1080/01431161.2018.1454625

Abstract: ABSTRACT This article verified the error between inversed land surface temperature (LST) and measured LST and developed the modified model based on Landsat 8 remote-sensing data. First, a single-channel algorithm was used to invert the… read more here.

Keywords: temperature; landsat remote; modified model; remote sensing ... See more keywords
Photo from wikipedia

A modified model of conductor roughness for manufacturing copper lines of printedcircuit board

Sign Up to like & get
recommendations!
Published in 2021 at "Circuit World"

DOI: 10.1108/cw-10-2019-0144

Abstract: Purpose The purpose of this paper is to establish an accurate model to quantify the effect of conductor roughness on insertion loss (IL) and provide improved measurements and suggestions for manufacturing good conductive copper lines… read more here.

Keywords: copper lines; model; conductor roughness; modified model ... See more keywords
Photo from wikipedia

The Modified Model of Third-Harmonic Shaping for a Surface-Mounted Permanent-Magnet Synchronous Motor Under Parallel Magnetization

Sign Up to like & get
recommendations!
Published in 2020 at "IEEE Transactions on Industry Applications"

DOI: 10.1109/tia.2020.3008369

Abstract: This article establishes an optimized third-harmonic shaping model in order to reach the goals of high power density and low torque ripple of the surface-mounted permanent magnet motor. The establishment of the model takes the… read more here.

Keywords: harmonic shaping; motor; modified model; surface mounted ... See more keywords
Photo from wikipedia

Patient Ability to Use Old versus New/Modified Model Adrenaline Autoinjection Emergency Medical Devices for Anaphylaxis in Prehospital Setting: A Systematic Review and Meta-Analysis

Sign Up to like & get
recommendations!
Published in 2022 at "Healthcare"

DOI: 10.3390/healthcare10020183

Abstract: Background: The goal of this study was to determine the individual’s ability to use new/modified model AAI compared to old model AAIs devices for anaphylaxis. Methods: The protocol was established a priori and published on… read more here.

Keywords: modified model; ability use; model; model aai ... See more keywords