Quench sensitivity of novel Al–Zn–Mg–Cu alloys containing different Cu contents
Sign Up to like & getrecommendations! Published in 2017 at "Rare Metals"
DOI: 10.1007/s12598-017-0981-y
Abstract: The effect of copper content on quench sensitivity in novel Al–Zn–Mg–Cu alloys containing high zinc content was investigated by Jominy end quench test. Electrical conductivity and hardness test, temperature collecting, and transmission electron microscopy (TEM)… read more here.
Keywords: quench sensitivity; sensitivity novel; alloys containing; sensitivity ... See more keywords
Study on the microwave sintering of the novel Mo–W–Cu alloys
Sign Up to like & getrecommendations! Published in 2021 at "Journal of Alloys and Compounds"
DOI: 10.1016/j.jallcom.2021.160584
Abstract: Abstract In this study, we fabricated a new type of Mo–W–Cu alloys by microwave sintering at a low temperature (1000 °C) in a short time (5 min) and characterized the phases, microstructures, and properties of the alloys.… read more here.
Keywords: microwave sintering; novel alloys; study microwave; sintering novel ... See more keywords
Development of novel Ti-Mo-Mn alloys for biomedical applications
Sign Up to like & getrecommendations! Published in 2020 at "Scientific Reports"
DOI: 10.1038/s41598-020-62865-4
Abstract: Due to excellent biocompatibility and corrosion resistance, the application of titanium alloys in orthopedic and dental implants has been increasing since the 1970s. However, the elasticity of these alloys as measured by their Young’s modulus… read more here.
Keywords: titanium alloys; titanium; novel alloys; development novel ... See more keywords
Novel Ultrafine-Grain Mg-Gd/Nd-Y-Ca Alloys with an Increased Ignition Temperature
Sign Up to like & getrecommendations! Published in 2023 at "Materials"
DOI: 10.3390/ma16031299
Abstract: Two novel ignition-resistant magnesium alloys, Mg-2Gd-2Y-1Ca and Mg-2Nd-1Y-1Ca, were prepared in the ultrafine-grain condition by equal channel angular pressing (ECAP). In addition, four commercial alloys—AZ31, AX41, AE42 and WE43—were prepared similarly as a reference. The… read more here.
Keywords: ignition temperature; novel alloys; ultrafine grain; grain ... See more keywords
Hot Deformation Behavior of Novel Al-Cu-Y(Er)-Mg-Mn-Zr Alloys
Sign Up to like & getrecommendations! Published in 2021 at "Metals"
DOI: 10.3390/met11101521
Abstract: The compression tests in a temperature range of 400–540 °C and strain rates of 0.1–15 s−1 were applied to novel Al-Cu-Y(Er)-Mg-Mn-Zr alloys to investigate their hot deformation behavior. The higher volume fraction of the intermetallic… read more here.
Keywords: hot deformation; deformation; deformation behavior; novel alloys ... See more keywords