Eco-friendly controllable synthesis of highly dispersed ZIF-8 embedded in porous Al2O3 and its hydrogenation properties after encapsulating Pt nanoparticles
Sign Up to like & getrecommendations! Published in 2018 at "Applied Catalysis B: Environmental"
DOI: 10.1016/j.apcatb.2018.01.022
Abstract: Abstract In this paper, a new strategy was proposed to synthesize a novel composite of highly dispersed ZIF-8 embedded in porous Al2O3 by a solvent-free method. This is a very simple, efficient, and eco-friendly method,… read more here.
Keywords: embedded porous; highly dispersed; dispersed zif; zif embedded ... See more keywords
Porous Al2O3 plates prepared by combing foaming and gel-tape casting methods for efficient collection of oil from water
Sign Up to like & getrecommendations! Published in 2019 at "Chemical Engineering Journal"
DOI: 10.1016/j.cej.2019.03.218
Abstract: Abstract Absorbent materials are considered as the most effective way of dealing with oil spill accidents and the increasing industrial oily wastewater leakages. However, poor recycling ability and low efficiency limit their application. This paper… read more here.
Keywords: al2o3 plates; gel tape; oil; foaming gel ... See more keywords
Removal of fluoride ions from ZnSO4 electrolyte by amorphous porous Al2O3 microfiber clusters: Adsorption performance and mechanism
Sign Up to like & getrecommendations! Published in 2020 at "Hydrometallurgy"
DOI: 10.1016/j.hydromet.2020.105455
Abstract: Abstract Amorphous porous Al2O3 microfiber clusters (AP-Al2O3-MCs) are developed by combining hydrothermal and roasting methods, which are applied to remove F− from the ZnSO4 electrolyte. Comprehensive characterization of AP-Al2O3-MCs is performed using X-ray diffraction (XRD),… read more here.
Keywords: al2o3 mcs; al2o3; amorphous porous; znso4 electrolyte ... See more keywords
Coating the porous Al2O3 substrate with a natural mineral of Nontronite-15A for fabrication of hydrogen-permeable palladium membranes
Sign Up to like & getrecommendations! Published in 2020 at "International Journal of Hydrogen Energy"
DOI: 10.1016/j.ijhydene.2019.04.102
Abstract: Abstract Substrate surface modification is a key pretreatment during fabrication of composite palladium membranes for hydrogen purification in hydrogen energy applications. The suspension of a natural porous material, Nontronite-15A mineral, without any organic additives was… read more here.
Keywords: palladium membranes; nontronite 15a; hydrogen; porous al2o3 ... See more keywords
Influences of Al metal and Al–Si alloys on in-situ synthesis of SiC nanowhiskers in porous Al2O3–SiC composites obtained by carbothermal reduction
Sign Up to like & getrecommendations! Published in 2021 at "Journal of Alloys and Compounds"
DOI: 10.1016/j.jallcom.2020.157182
Abstract: Abstract SiC nanowhiskers are good reinforcing phases for enhancing the strength and thermal shock resistance of porous Al2O3–SiC composites. In this work, Al metal and Al–Si alloys were used as reducing agents to assist the… read more here.
Keywords: synthesis; metal alloys; porous al2o3; sic composites ... See more keywords
Fabrication of porous Al2O3–MgO–TiO2 ceramic monoliths by the combination of nanoemulsion templating and temperature-induced forming
Sign Up to like & getrecommendations! Published in 2021 at "Journal of The European Ceramic Society"
DOI: 10.1016/j.jeurceramsoc.2020.09.056
Abstract: Abstract Porous ceramics have attracted considerable attention owing to the increased interest in their applications. Porous Al2O3–MgO–TiO2 ceramic monoliths were synthesized using nanoemulsion templating and temperature-induced forming method. The nanoemulsion (NE) is prepared by the… read more here.
Keywords: al2o3 mgo; porous al2o3; nanoemulsion; ceramic monoliths ... See more keywords
Design and Preparation of the Phase Change Materials Paraffin/Porous Al2O3@Graphite Foams with Enhanced Heat Storage Capacity and Thermal Conductivity
Sign Up to like & getrecommendations! Published in 2017 at "ACS Sustainable Chemistry & Engineering"
DOI: 10.1021/acssuschemeng.7b00889
Abstract: Porous Al2O3@graphite foams (PAGFs) were directly prepared by a particle-stabilized foaming method, with 40 vol % Al2O3 particles and different proportions of sucrose. The as-prepared PAGFs demonstrate three-dimensional interpenetrating structures and high porosities according to… read more here.
Keywords: graphite foams; al2o3 graphite; porous al2o3; heat ... See more keywords