Articles with "pre strain" as a keyword



Influence of pre-strain on cryogenic tensile properties of 316LN austenitic stainless steel

Sign Up to like & get
recommendations!
Published in 2020 at "Cryogenics"

DOI: 10.1016/j.cryogenics.2020.103058

Abstract: Abstract In the present work, influences of room temperature tensile pre-strain on cryogenic tensile properties of 316LN austenitic stainless steel (SS) were investigated. The tensile properties of the 316LN SS with various tensile pre-straining amounts… read more here.

Keywords: tensile properties; pre strain; pre strained; pre ... See more keywords
Photo from wikipedia

Effect of tensile pre-strain on low-cycle fatigue behaviour of 7050-T6 aluminium alloy

Sign Up to like & get
recommendations!
Published in 2020 at "Engineering Failure Analysis"

DOI: 10.1016/j.engfailanal.2020.104592

Abstract: Abstract The present study addresses the effect of tensile pre-strain histories on cyclic plastic deformation behaviour of 7050-T6 aluminium alloy. Low-cycle fatigue tests are conducted under fully-reversed conditions, with 8% tensile pre-strain, 4% tensile pre-strain,… read more here.

Keywords: pre strain; microscopy; tensile pre; fatigue ... See more keywords

Effect of pre-strain on fatigue crack growth behavior for commercial pure titanium at ambient temperature

Sign Up to like & get
recommendations!
Published in 2018 at "International Journal of Fatigue"

DOI: 10.1016/j.ijfatigue.2018.07.036

Abstract: Abstract In this paper, the effects of pre-strain on fatigue crack growth rate are investigated considering wide ranges of load amplitudes and load ratios for commercial titanium alloy (CP-Ti). Considering the influences of load ratio… read more here.

Keywords: fatigue crack; pre strain; load; crack ... See more keywords

Effects of pre-strain and stress level on stress relaxation ageing behaviour of 2195 Al–Li alloy: Experimental and constitutive modelling

Sign Up to like & get
recommendations!
Published in 2021 at "Journal of Alloys and Compounds"

DOI: 10.1016/j.jallcom.2020.156829

Abstract: Abstract In the present work, the stress relaxation behaviour, mechanical properties and microstructural evolution of 2195 Al–Li alloy with different pre-strains (0%, 2% and 4%) have been experimentally investigated under different initial stress levels at… read more here.

Keywords: pre strain; 2195 alloy; stress relaxation; relaxation ... See more keywords
Photo from wikipedia

Characterizing the back stress of ultra-thin metallic sheet via pre-strain tension/bending process

Sign Up to like & get
recommendations!
Published in 2020 at "Journal of Materials Processing Technology"

DOI: 10.1016/j.jmatprotec.2019.116560

Abstract: Abstract The buckling and instability of the ultra-thin sheet metal specimens subjected to compressive loading present an evident difficulty for the investigation of Bauschinger effect by using traditional tensile-compressive loading tests. In that regard, a… read more here.

Keywords: back stress; pre strain; ultra thin; strain ... See more keywords
Photo from wikipedia

Effects of pre-strain on the surface residual stress and corrosion behavior of an Al-Zn-Mg-Cu alloy plate

Sign Up to like & get
recommendations!
Published in 2020 at "Materials Characterization"

DOI: 10.1016/j.matchar.2020.110129

Abstract: Abstract The surface residual stress as well as corrosion behavior of an Al-Zn-Mg-Cu alloy plate is investigated under various pre-deformation conditions via X-ray diffraction, transmission electron microscopy, laser scanning microscope, open circuit potentials and electrochemical… read more here.

Keywords: residual stress; pre strain; surface residual; corrosion ... See more keywords
Photo from wikipedia

Pre-strain mediated fast natural aging in a dilute Mg-Zn-Ca-Sn-Mn alloy

Sign Up to like & get
recommendations!
Published in 2021 at "Scripta Materialia"

DOI: 10.1016/j.scriptamat.2021.113924

Abstract: Abstract A remarkable natural aging (NA) hardening response induced by pre-strain treatment, i.e. an evident increment of flow stress from ~138 MPa to ~163 MPa within only 48h, was observed in a dilute Mg–1.0Zn–0.45Ca–0.33Sn–0.2Mn (wt.%,… read more here.

Keywords: mediated fast; natural aging; pre strain; strain mediated ... See more keywords

Effect of pre-strain on microstructure evolution and fracture behavior of undermatching X80 pipeline steel girth weld

Sign Up to like & get
recommendations!
Published in 2024 at "Materials Research Express"

DOI: 10.1088/2053-1591/ad43bf

Abstract: This work aims to study the effect of pre-strain on the fracture behavior of X80 pipeline girth weld joint, a comprehensive analysis was conducted on the microstructure and mechanical properties of the girth weld before… read more here.

Keywords: fracture; x80 pipeline; pre strain; strain ... See more keywords

Effect of pre-strain and KMnO4 oxidation of carbon nanotubes embedded in polyurethane on strain dependent electrical resistance of the composite

Sign Up to like & get
recommendations!
Published in 2017 at "Sensor Review"

DOI: 10.1108/sr-05-2017-0079

Abstract: Purpose The synergistic effect of functionalization of multi-walled carbon nanotubes (CNT) using KMnO4 oxidation and initial tensile deformation on the electrical resistance of nanotube network/polyurethane composite subjected to elongation was studied. Design/methodology/approach Though the initial… read more here.

Keywords: pre strain; carbon; oxidation; effect ... See more keywords

Bake hardening behavior and microstructure evolution of hot-rolled high strength steel under different temperatures and pre-strain rates

Sign Up to like & get
recommendations!
Published in 2025 at "Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture"

DOI: 10.1177/09544054251395183

Abstract: Press forming and paint curing are essential processes in automobile manufacturing. Moreover, the pre-strain and baking effects induced by these processes on steel plates are significant. This study investigated the effects of baking temperature and… read more here.

Keywords: temperature; carbon; bake hardening; steel ... See more keywords

Measurement of two-dimensional residual stress in nanocrystalline superelastic NiTi fabricated with pre-strain laser shock peening

Sign Up to like & get
recommendations!
Published in 2022 at "Mathematics and Mechanics of Solids"

DOI: 10.1177/10812865221090589

Abstract: The measurement of residual stress is a challenging issue in industrial fields. In this work, focused ion beam (FIB) and digital image correlation (DIC) are combined together to measure the two-dimensional residual stress in nanocrystalline… read more here.

Keywords: stress; two dimensional; residual stress; pre strain ... See more keywords