Sign Up to like & get
recommendations!
1
Published in 2021 at "International Journal of Fatigue"
DOI: 10.1016/j.ijfatigue.2021.106260
Abstract: Abstract The present work aims to examine the low cycle fatigue (LCF) behavior of dual-phase (DP590) steel subjected to different pre-straining (uniaxial and equi-biaxial) paths. The LCF tests reveal all specimens showed continuous cyclic softening…
read more here.
Keywords:
pre;
cycle fatigue;
low cycle;
biaxial pre ... See more keywords
Sign Up to like & get
recommendations!
1
Published in 2018 at "International Journal of Mechanical Sciences"
DOI: 10.1016/j.ijmecsci.2018.02.024
Abstract: Abstract The most common failure criterion in sheet metal forming operations is the forming limit diagram (FLD). Typically, the FLD is evaluated with the Nakajima test, which is a stretch forming-based test that allows the…
read more here.
Keywords:
punch;
analysis;
sheet;
pre straining ... See more keywords
Sign Up to like & get
recommendations!
1
Published in 2022 at "Scripta Materialia"
DOI: 10.1016/j.scriptamat.2021.114272
Abstract: Abstract The pre-deformation effects of hydrogen embrittlement on nitrogen-doped duplex stainless steel were investigated using tensile testing. Hydrogen pre-charging and pre-straining were adopted, which increased the yield strength, but decreased the ductility. Silver decoration revealed…
read more here.
Keywords:
nitrogen doped;
hydrogen;
doped duplex;
pre straining ... See more keywords
Sign Up to like & get
recommendations!
1
Published in 2020 at "Theoretical and Applied Fracture Mechanics"
DOI: 10.1016/j.tafmec.2020.102630
Abstract: Abstract This paper presents the influence of different pre-straining paths on the notch fatigue performance of Dual Phase 600 steel. Initially, pre-straining is done in rolling (or transverse) direction. Then tensile and notch fatigue specimens…
read more here.
Keywords:
notch fatigue;
direction;
pre;
pre straining ... See more keywords
Sign Up to like & get
recommendations!
0
Published in 2018 at "Defect and Diffusion Forum"
DOI: 10.4028/www.scientific.net/ddf.385.364
Abstract: The present study deals with the effect of pre-deformation technique of AA2519 alloy (Al–5.64Cu–0.33Mn–0.23Mg–0.15Zr–0.11Ti–0.09V–0.08Fe–0.01Si (wt. %)) under T8 tempers, on condition that intermediate strains are equal. After undergoing T87 by pre-stretching and peak ageing the…
read more here.
Keywords:
alloy;
effect pre;
effect;
pre straining ... See more keywords