Novel 3D printing method to reinforce implant‐supported denture fiberglass as material for implant prosthesis: A pilot study
Sign Up to like & getrecommendations! Published in 2022 at "Clinical and Experimental Dental Research"
DOI: 10.1002/cre2.568
Abstract: Despite a large amount of materials and methods to make an implant‐supported denture, nowadays there is no gold standard. Every solution has pros and cons that guide the clinician and the technician to choose the… read more here.
Keywords: supported denture; novel printing; printing method; method reinforce ... See more keywords
Development of composite springs using 4D printing method
Sign Up to like & getrecommendations! Published in 2019 at "Composite Structures"
DOI: 10.1016/j.compstruct.2018.12.003
Abstract: Abstract Composite springs have been used in many engineering applications, particularly in the transportation industry. This is due to their light weight, good stiffness, good strength, good corrosion and fatigue resistances. Normally special molds need… read more here.
Keywords: composite structures; springs using; using printing; development composite ... See more keywords
Large-area non-fullerene organic solar cell modules fabricated by a temperature-independent printing method.
Sign Up to like & getrecommendations! Published in 2020 at "ACS applied materials & interfaces"
DOI: 10.1021/acsami.0c12190
Abstract: Despite recent breakthroughs in the fabrication of spin-coated small-area devices (≤0.1 cm2) with power conversion efficiencies (PCEs) of more than 17%, printed large-area organic solar cells (OSCs) are significantly less efficient because of the intrinsic… read more here.
Keywords: organic solar; area non; area; non fullerene ... See more keywords
A high speed electrohydrodynamic (EHD) jet printing method for line printing
Sign Up to like & getrecommendations! Published in 2017 at "Journal of Micromechanics and Microengineering"
DOI: 10.1088/1361-6439/aa7c6b
Abstract: Electrohydrodynamic (EHD) jet printing has drawn attention due to its capability to produce smaller dots and patterns with finer lines when compared to those obtained from using conventional inkjet printing. Previous studies have suggested that… read more here.
Keywords: line; speed; jet printing; printing method ... See more keywords
Nanoink bridge-induced capillary pen printing for chemical sensors.
Sign Up to like & getrecommendations! Published in 2018 at "Nanotechnology"
DOI: 10.1088/1361-6528/aac84a
Abstract: Single-walled carbon nanotubes (SWCNTs) are used as a key component for chemical sensors. For miniature scale design, a continuous printing method is preferred for electrical conductance without damaging the substrate. In this paper, a non-contact… read more here.
Keywords: bridge; nanoink bridge; pen printing; chemical sensors ... See more keywords
Structural Behavior of a Composite Curtain Wall Fabricated by the Fused Deposition Modeling 3D Printing Method
Sign Up to like & getrecommendations! Published in 2022 at "Polymers"
DOI: 10.3390/polym14071431
Abstract: In this era of the fourth industrial revolution, the integration of big data and 3D printing technology with the construction industry has maximized productivity. Currently, there is an active effort to research the optimal cladding… read more here.
Keywords: structure; modeling printing; printing method; curtain wall ... See more keywords