Modelling and multi-objective optimization of surface roughness and kerf taper angle in abrasive water jet machining of steel
Sign Up to like & getrecommendations! Published in 2018 at "Journal of the Brazilian Society of Mechanical Sciences and Engineering"
DOI: 10.1007/s40430-018-1186-5
Abstract: Abrasive water jet machining (AWJM) is a popular method used for cutting purposes. It uses a thin jet of ultra-high pressure water and abrasive slurry to cut the material and the cutting is mainly by… read more here.
Keywords: taper angle; roughness kerf; surface roughness; surface ... See more keywords
The Effect of a Taper Angle on Micro-Compression Testing of Mo-B-C Coatings
Sign Up to like & getrecommendations! Published in 2020 at "Materials"
DOI: 10.3390/ma13143054
Abstract: This research was devoted to studying the influence of the taper angle on the micro-compression of micro-pillars fabricated from near-amorphous and nanocrystalline Mo-B-C coatings. A series of micro-pillars with a taper angle between 4–14° was… read more here.
Keywords: angle; micro compression; taper angle; angle micro ... See more keywords
Machining of Triangular Holes in D2 Steel by the Use of Non-Conventional Electrodes in Die-Sinking Electric Discharge Machining
Sign Up to like & getrecommendations! Published in 2023 at "Materials"
DOI: 10.3390/ma16103865
Abstract: Electric discharge machining is relatively a slow process in terms of machining time and material removal rate. The presence of overcut and the hole taper angle caused by the excessive tool wear are other challenges… read more here.
Keywords: taper angle; non conventional; electric discharge; discharge machining ... See more keywords