Spontaneous formation of filled-shell CsI-Xenon solid solutions under high temperature and high pressure
Sign Up to like & getrecommendations! Published in 2021 at "Computational Materials Science"
DOI: 10.1016/j.commatsci.2021.110355
Abstract: Abstract Different stoichiometries compounds formed by filled-shell (FS) insulators (e.g., xenon) have been extensively predicted and successfully synthesized under extreme conditions. However, theoretical prediction on solid solution formed by FS materials is lacking. Here, by… read more here.
Keywords: high pressure; solid solutions; filled shell; high temperature ... See more keywords
Effect of Si/Ti additive on the preparation and properties of cBN-diamond composite sintered by high-temperature and high-pressure
Sign Up to like & getrecommendations! Published in 2019 at "Diamond and Related Materials"
DOI: 10.1016/j.diamond.2019.107513
Abstract: Abstract CBN-diamond composites with Si/Ti additive were synthesized by high temperature and high-pressure (HPHT) method. The optimum molar ratio of Si/Ti was proposed. Effect of Si/Ti additive on performance of cBN-diamond composites was systematically investigated.… read more here.
Keywords: high pressure; high temperature; effect additive; diamond ... See more keywords
Microstructure characterization of W-Cu alloy sheets produced by high temperature and high pressure deformation technique
Sign Up to like & getrecommendations! Published in 2017 at "Materials Letters"
DOI: 10.1016/j.matlet.2017.06.090
Abstract: Abstract W-Cu alloy sheets were fabricated in this study by multiple high temperature and high pressure (multi-HTHP) deformation technique. Crystalline structures and phase composition of W-Cu alloy sheets were investigated by transmission electron microscopy and… read more here.
Keywords: alloy; alloy sheets; high temperature; temperature high ... See more keywords
Low temperature and high strain rate superplastic flow in structural ceramics induced by strong electric-field
Sign Up to like & getrecommendations! Published in 2018 at "Scripta Materialia"
DOI: 10.1016/j.scriptamat.2017.11.042
Abstract: Abstract High-strength structural ceramics with sub-micron grain sizes can exhibit superplasticity, but the superplasticity appears at high temperatures and low strain rates. Low temperature and high speed superplastic flow in structural ceramics was achieved by… read more here.
Keywords: low temperature; structural ceramics; field; temperature high ... See more keywords
Laboratory Study of CO2 Foam Flooding in High Temperature, High Salinity Carbonate Reservoirs Using Co-injection Technique
Sign Up to like & getrecommendations! Published in 2017 at "Energy & Fuels"
DOI: 10.1021/acs.energyfuels.7b03432
Abstract: In this research, an ethoxylated amine surfactant is co-injected with CO2 in a series of coreflooding experiments at typical Middle Eastern reservoir conditions of high temperature, high salinity, and in situ foam is generated to… read more here.
Keywords: foam; high temperature; temperature high; foam quality ... See more keywords
Experimental High-Temperature, High-Pressure Density Measurement and Perturbed-Chain Statistical Associating Fluid Theory Modeling of Dimethyl Sulfoxide, Isoamyl Acetate, and Benzyl Alcohol
Sign Up to like & getrecommendations! Published in 2019 at "Journal of Chemical & Engineering Data"
DOI: 10.1021/acs.jced.9b00396
Abstract: Experimental high-temperature, high-pressure (HTHP) density of three solvents including dimethyl sulfoxide, benzyl alcohol, and isoamyl acetate was measured at temperatures of 293.15–473.15 K and pressures up to 35–37.5 MPa. The density was measured with an… read more here.
Keywords: high temperature; experimental high; temperature high; density ... See more keywords
Seismic Response to Injection Well Stimulation in a High‐Temperature, High‐Permeability Reservoir
Sign Up to like & getrecommendations! Published in 2019 at "Geochemistry, Geophysics, Geosystems"
DOI: 10.1029/2019gc008243
Abstract: Author(s): Hopp, C; Sewell, S; Mroczek, S; Savage, M; Townend, J | Abstract: ©2019. American Geophysical Union. All Rights Reserved. Fluid injection into the Earth's crust can induce seismic events that cause damage to local… read more here.
Keywords: high temperature; high permeability; temperature high; permeability ... See more keywords
The general corrosion behavior of ENiCrFe-7 weld overlay cladding material in deoxygenated high-temperature and high-pressure water
Sign Up to like & getrecommendations! Published in 2019 at "Journal of Nuclear Science and Technology"
DOI: 10.1080/00223131.2019.1571453
Abstract: ABSTRACT The general corrosion behavior of Alloy ENiCrFe-7 in deoxygenated high-temperature and high-pressure water was investigated. The results showed that the precipitates of Alloy ENiCrFe-7 included niobium carbide and Al-Ti-O compounds, and the weight gain… read more here.
Keywords: high temperature; temperature high; deoxygenated high; corrosion ... See more keywords
A new high temperature, high heating rate, low axial gradient capillary heater
Sign Up to like & getrecommendations! Published in 2023 at "Journal of Synchrotron Radiation"
DOI: 10.1107/s1600577522009845
Abstract: A new high-temperature capillary heater design suitable for synchrotron X-ray diffraction, total scattering and EXAFS experiments is described. read more here.
Keywords: capillary heater; temperature high; new high; high temperature ... See more keywords
Experimental Investigation on a Novel Particle Polymer for Enhanced Oil Recovery in High Temperature and High Salinity Reservoirs
Sign Up to like & getrecommendations! Published in 2021 at "Journal of Chemistry"
DOI: 10.1155/2021/5593038
Abstract: Conventional polymer flooding include polymer flooding, surfactant-polymer flooding (SP), alkaline-surfactant-polymer flooding (ASP), and crosslinked polymer gel flooding. However, these technologies in oilfield, especially in high temperature and high salinity, are limited due to the poor… read more here.
Keywords: high temperature; polymer; temperature high; salinity ... See more keywords
Design of Drilling Fluid of High Temperature and High Pressure Resistance in Well Drilling of Deepwater Area
Sign Up to like & getrecommendations! Published in 2019 at "Journal of Coastal Research"
DOI: 10.2112/si83-011.1
Abstract: ABSTRACT Zhu, T.; Dai, X., and Ai, F., 2018. Design of drilling fluid of high temperature and high pressure resistance in well drilling of deepwater area. In: Liu, Z.L. and Mi, C. (eds.), Advances in… read more here.
Keywords: drilling fluid; high pressure; temperature; high temperature ... See more keywords