Low temperature sintering of lead–free (Bi1/2Na1/2)TiO3-SrTiO3-BiFeO3 piezoelectric ceramics by adding excess CuO
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Electroceramics"
DOI: 10.1007/s10832-018-0151-0
Abstract: This study examined the microstructures, crystal structures, and electrical properties of 0.01 mol CuO–added (1–x)(Bi1/2Na1/2)TiO3–xSrTiO3–2BiFeO3 (BNST100x–2BF, x = 0.20 ~ 0.28) ceramics synthesized at two different sintering temperatures. The sintering temperature of the BNST100x–2BF ceramics could be decreased… read more here.
Keywords: bi1 2na1; cuo; low temperature; temperature ... See more keywords
Low temperature sintering and dielectric properties of Ba3(VO4)2 microwave ceramics using Co2O3 additives
Sign Up to like & getrecommendations! Published in 2017 at "Journal of Materials Science: Materials in Electronics"
DOI: 10.1007/s10854-017-7794-5
Abstract: The Ba3(VO4)2–x wt% Co2O3 (x = 0.5–5) ceramics were prepared by the solid state reaction method in order to reduce the sintering temperature. The effects of the Co2O3 additions on the phase composition, microstructures, sintering characteristics and… read more here.
Keywords: temperature sintering; low temperature; temperature; ba3 vo4 ... See more keywords
Low-Temperature Sintering Behavior (≤ 400°C) of Micro-sized Silver Particles Decorated by Silver Nanoparticles Through Surface Iodination
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Electronic Materials"
DOI: 10.1007/s11664-018-6400-9
Abstract: This paper introduces a facile and effective route to decorate micro-sized silver particle surfaces with Ag/AgI nanoclusters through a wet chemical reaction at room temperature using iodine and ethanol as reactant and solvent, respectively. Photosensitivity… read more here.
Keywords: temperature sintering; low temperature; micro sized; silver ... See more keywords
Low-Temperature Sintering of Gahnite Ceramic Using Cu-Nb-O Additive and Evaluation of Dielectric and Thermal Properties
Sign Up to like & getrecommendations! Published in 2020 at "Journal of Electronic Materials"
DOI: 10.1007/s11664-020-08346-w
Abstract: Low-temperature sintering of gahnite (ZnAl2O4) ceramic, which has the potential to exhibit higher thermal conductivity than alumina but sinters densely at a moderate temperature of approximately 1500°C, has been investigated. When adding only 5 wt.%… read more here.
Keywords: temperature sintering; low temperature; temperature; gahnite ceramic ... See more keywords
Effect of the temperature and sintering time on the thermal, structural, morphological, and vibrational properties of hydroxyapatite derived from pig bone
Sign Up to like & getrecommendations! Published in 2017 at "Ceramics International"
DOI: 10.1016/j.ceramint.2017.03.046
Abstract: Abstract This paper focuses in the study of the effect of the temperature and sintering time on structural, morphological, thermal, and vibrational properties of hydroxyapatite obtained from pig bone (BHA). A three-step process was used… read more here.
Keywords: temperature sintering; effect temperature; structural morphological; time ... See more keywords
Pseudo low-temperature sintering effect and microstructure evolution of SiBCO ceramics
Sign Up to like & getrecommendations! Published in 2020 at "Ceramics International"
DOI: 10.1016/j.ceramint.2020.11.248
Abstract: Abstract Incorporation of B atoms into SiOC ceramic can suppress the carbothermal reaction and improve the thermal stability. Polymer derived ceramics from single source preceramic polymer is a good solution but the B/Si ratio could… read more here.
Keywords: temperature sintering; low temperature; pseudo low; sintering effect ... See more keywords
Origin of high piezoelectricity in low-temperature sintering PZT-based relaxor ferroelectric ceramics
Sign Up to like & getrecommendations! Published in 2020 at "Journal of Alloys and Compounds"
DOI: 10.1016/j.jallcom.2020.157930
Abstract: Abstract Multilayer piezoelectric devices need to co-sinter the piezoelectric ceramic layers and the Ag-rich Ag–Pd internal electrode layers at a low temperature (less than the Ag melting point of 961.78 °C), and need to use Sn–Zn-based… read more here.
Keywords: temperature sintering; low temperature; temperature; origin high ... See more keywords
Effects of high pressure on the low-temperature sintering of dense amorphous SiBCN monoliths
Sign Up to like & getrecommendations! Published in 2018 at "Journal of The European Ceramic Society"
DOI: 10.1016/j.jeurceramsoc.2018.04.061
Abstract: Abstract In this study, amorphous SiBCN powders were mechanical milled and consolidated by low-temperature sintering at different pressure to provide an insight into the densification and mechanical behavior of dense amorphous SiBCN monoliths. Results show… read more here.
Keywords: temperature sintering; low temperature; amorphous sibcn; sibcn monoliths ... See more keywords
A promising strategy for fabricating high-performance stereocomplex-type polylactide products via carbon nanotubes-assisted low-temperature sintering
Sign Up to like & getrecommendations! Published in 2019 at "Polymer"
DOI: 10.1016/j.polymer.2018.12.032
Abstract: Abstract Recently, powder metallurgy inspired low-temperature (below the melting temperature) sintering has been proposed as an innovative technology for the processing of eco-friendly stereocomplex-type polylactide (SC-PLA) from its nascent powder, without triggering noticeable thermal degradation.… read more here.
Keywords: carbon nanotubes; temperature sintering; temperature; low temperature ... See more keywords
Low-Temperature Sintering of a Garnet-Type Li6.5La3Zr1.5Ta0.5O12 Solid Electrolyte and an All-Solid-State Lithium-Ion Battery.
Sign Up to like & getrecommendations! Published in 2023 at "ACS applied materials & interfaces"
DOI: 10.1021/acsami.3c01038
Abstract: Garnet-type Ta-substituted Li7La3Zr2O12 materials attract considerable attention as solid electrolytes for use in future oxide-based all-solid-state lithium-ion batteries owing to their superior ionic conductivity and chemical and electrochemical stabilities. However, high-temperature sintering above 1000 °C,… read more here.
Keywords: temperature; lithium ion; low temperature; temperature sintering ... See more keywords
Influence of the temperature of sintering under pressure on the structure and mechanical properties of a composite material AMg2 / γ-Al2O3 nanofibres
Sign Up to like & getrecommendations! Published in 2019 at "Letters on Materials"
DOI: 10.22226/2410-3535-2019-1-75-80
Abstract: A nanocrystalline composite powder based on an AlMg2 alloy reinforced with 1 wt.% γ-Al2O3 nanofibers was obtained in a planetary mill by mechanical synthesis. It was consolidated by sintering under pressure at a temperature of… read more here.
Keywords: temperature sintering; temperature; composite material; increase ... See more keywords