Articles with "wear behavior" as a keyword



Photo by markusspiske from unsplash

Effect of Load and Sliding Rate on the Wear Behavior of Ti-Containing TWIP Steel

Sign Up to like & get
recommendations!
Published in 2017 at "Journal of Materials Engineering and Performance"

DOI: 10.1007/s11665-017-2635-5

Abstract: This work studied the effects of load and sliding rate on the wear behavior under dry sliding contact of a Ti-containing high-Mn austenitic Fe-21Mn-1.2Si-1.6Al-0.45C TWIP steel. The wear behavior was investigated using a pin-on-ring configuration.… read more here.

Keywords: twip steel; sliding rate; wear behavior; microscopy ... See more keywords
Photo by markusspiske from unsplash

Wear Behavior of Laser-Cladded Co-Cr-Mo Coating on γ-TiAl Substrate

Sign Up to like & get
recommendations!
Published in 2017 at "Journal of Materials Engineering and Performance"

DOI: 10.1007/s11665-017-2745-0

Abstract: In this study, laser cladding of Co-Cr-Mo alloy on a γ-TiAl substrate was performed to investigate the wear behavior of coated and uncoated TiAl alloy at room temperature. Dry sliding wear tests were conducted for… read more here.

Keywords: abrasive wear; tial substrate; laser; wear behavior ... See more keywords
Photo by nci from unsplash

Investigation of the Effect of Residual Stress Gradient on the Wear Behavior of PVD Thin Films

Sign Up to like & get
recommendations!
Published in 2018 at "Journal of Materials Engineering and Performance"

DOI: 10.1007/s11665-018-3132-1

Abstract: The control of residual stresses has been seldom investigated in multilayer coatings dedicated to improvement of wear behavior. Here, we report the preparation and characterization of superposed structures composed of Cr, CrN and CrAlN layers.… read more here.

Keywords: crn craln; microscopy; pvd; wear behavior ... See more keywords
Photo by markusspiske from unsplash

Wear Behavior of Vanadium and V-Ti-Ta Alloys under Reciprocating Sliding Conditions

Sign Up to like & get
recommendations!
Published in 2019 at "Journal of Materials Engineering and Performance"

DOI: 10.1007/s11665-019-04090-3

Abstract: Vanadium and newly developed V-Ti-Ta alloys have been systematically investigated for wear characteristics using ball-on-flat reciprocative sliding experiments. These materials have been tested at different sliding conditions (load and frequency) against hardened steel (AFBMA Grade… read more here.

Keywords: vanadium alloys; sliding conditions; wear behavior; wear rate ... See more keywords
Photo by matreding from unsplash

Dry Sliding Wear Behavior of AZ91 Alloy Processed by Rotary-Die Equal Channel Angular Pressing

Sign Up to like & get
recommendations!
Published in 2020 at "Journal of Materials Engineering and Performance"

DOI: 10.1007/s11665-020-04883-x

Abstract: This research examines the effect of wear testing parameters on the wear behavior of AZ91 alloy prepared through rotary-die equal channel angular pressing (RD-ECAP). An AZ91 alloy was processed by RD-ECAP method at 573 K for… read more here.

Keywords: alloy; rotary die; az91 alloy; die equal ... See more keywords
Photo from archive.org

Wear map for sliding wear behavior of Cu-15Ni-8Sn alloy against bearing steel under oil-lubricated condition

Sign Up to like & get
recommendations!
Published in 2020 at "Journal of Central South University"

DOI: 10.1007/s11771-020-4297-y

Abstract: Wear behaviors of a peak-aged Cu-15Ni-8Sn alloy fabricated by powder metallurgy were investigated. The results indicated that the friction coefficients and the wear rates of Cu-15Ni-8Sn alloy within a normal load range of 50-700 N… read more here.

Keywords: wear behavior; 15ni 8sn; wear map; 8sn alloy ... See more keywords
Photo by eriic from unsplash

Dry Wear Behavior of Cladded NiCoCrAlY Coating on Cast Iron at Elevated Temperatures

Sign Up to like & get
recommendations!
Published in 2019 at "JOM"

DOI: 10.1007/s11837-019-03858-1

Abstract: To improve the service life of valve retainer in the engine exhaust system, the NiCoCrAlY alloy coating was fabricated on compacted graphite cast iron by laser cladding. Microstructure and high-temperature wear resistance of the coating… read more here.

Keywords: wear behavior; behavior cladded; cast iron; dry wear ... See more keywords
Photo by matreding from unsplash

Correlations Between Microstructure and Dry Friction Wear Behavior of Zn–38Al–3.5Cu–1.2 Mg Alloy Reinforced with SiC Nanoparticles

Sign Up to like & get
recommendations!
Published in 2019 at "Transactions of the Indian Institute of Metals"

DOI: 10.1007/s12666-019-01725-w

Abstract: In order to improve the tribological properties of zinc-based alloy, SiC nanoparticles (an average grain size of 100 nm) were reinforced into Zn–38Al–3.5Cu–1.2 Mg alloy through a high-pressure jetting powder and semisolid stirring-assisted ultrasonic vibration process. In… read more here.

Keywords: alloy; 38al 5cu; 5cu alloy; friction ... See more keywords
Photo by markusspiske from unsplash

Wear behavior and mechanism of TiB2-based ceramic inserts in high-speed cutting of Ti6Al4V alloy

Sign Up to like & get
recommendations!
Published in 2020 at "Ceramics International"

DOI: 10.1016/j.ceramint.2019.12.041

Abstract: Abstract Starting from TiB2, Mo, Co, and C powders, TiB2-based ceramics for cutting tools were prepared by hot-pressing at 1900 °C. The densification, microstructure and mechanical properties of TiB2–Mo–Co and TiB2–Mo–Co–C samples were evaluated. More importantly,… read more here.

Keywords: ti6al4v alloy; wear behavior; tib2; tib2 based ... See more keywords
Photo from wikipedia

Wet abrasive wear behavior of WC-based cermet coatings prepared by HVOF spraying

Sign Up to like & get
recommendations!
Published in 2021 at "Ceramics International"

DOI: 10.1016/j.ceramint.2020.09.009

Abstract: Abstract In this study, three kinds of WC-based cermet coatings including WC–CoCr coating, WC–Ni coating and WC–Cr3C2–Ni coating were prepared by the high-velocity oxygen-fuel (HVOF) spraying process. Scanning electron microscopy (SEM), energy disperse spectroscopy (EDS)… read more here.

Keywords: abrasive wear; cermet coatings; wear behavior; wear ... See more keywords
Photo from wikipedia

Interfacial morphology and corrosion-wear behavior of cast Fe-3.5 wt.% B steel in liquid zinc

Sign Up to like & get
recommendations!
Published in 2018 at "Corrosion Science"

DOI: 10.1016/j.corsci.2017.12.003

Abstract: Abstract The corrosion-wear behavior of Fe-3.5 wt.%B steel in liquid zinc was investigated via the block-against-ring technique. Owing to the protective ability of the Fe2B phase, this steel exhibited better corrosion-wear resistance than a 316L stainless… read more here.

Keywords: steel liquid; liquid zinc; corrosion wear; wear behavior ... See more keywords